Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Top Knobs Asbury pull is a transitional bar pull for cabinet doors and drawer fronts, finished in Brushed Satin Nickel and sized to mount on the most common hole pattern in kitchen cabinetry.
The 3-3/4 inch center-to-center dimension is the standard drilling interval on a wide range of base drawers, upper doors, and bath vanity fronts. It is the spacing that most cabinet shops drill as a default, which makes this pull a frequent choice for direct replacements as well as new builds. On a mid-width drawer front it sits centered with room to spare on either side. On a shaker or slab upper door it reads proportional without competing with the panel for attention. If the existing holes in a cabinet are already at 3-3/4 inch centers, this pull drops in without additional drilling.
The pull is cast in zinc and finished in Brushed Satin Nickel. The brushed surface introduces a fine directional grain that softens the nickel tone rather than reflecting it as a mirror. In a kitchen under mixed lighting — natural from a window, task from undercabinets — a brushed finish stays consistent rather than flaring at certain angles the way a polished nickel does. The result is hardware that reads as silver without demanding attention. Brushed Satin Nickel also tolerates the routine contact of a kitchen or bath without showing every fingerprint, which matters on hardware that gets touched dozens of times a day.
This pull is a natural fit for transitional kitchens and baths where the hardware needs to work alongside both warm wood tones and painted fronts without tipping hard toward contemporary or traditional. At 5 inches overall with a slim 9/16 inch bar, it has the restraint of a contemporary piece and the warmth of a nickel finish that has always read as classic. It suits designers and cabinet shops that run a consistent hole pattern across a project and want a single pull that works across doors and drawers alike. It also suits homeowners replacing worn or dated hardware on existing cabinets drilled to the 3-3/4 inch standard, where the priority is a clean swap with no patching or redrilling.
Yes. The 3-3/4 inch spacing is the same standard interval as 96 mm, so this pull seats directly onto existing holes drilled to either measurement.
Polished Nickel has a mirror-bright reflective surface. Brushed Satin Nickel is matte-directional, softer in sheen, and less likely to show fingerprints or lighting inconsistencies.
The Asbury series includes companion pieces in the same design language and finish, so knobs and pulls from the same collection coordinate naturally.
Yes. A bar pull of this size works on both doors and drawers, and the 3-3/4 inch spacing can be drilled into a door front the same way it is in a drawer face.
Choose this pull when the hole pattern is already there, the finish needs to stay neutral across the room, and the hardware should settle into the cabinetry rather than stand apart from it.
Sold In: 1 Each