Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Top Knobs Asbury pull is a transitional bar pull for cabinet doors and drawer fronts, mounting on the 3-3/4 inch (95 mm) center-to-center spacing found across a wide range of standard cabinetry.
The 3-3/4 inch center-to-center is one of the most prevalent hole patterns in residential cabinetry, which makes this pull a straightforward replacement option when existing doors and drawers are already drilled to that spacing. No new holes, no filler plugs. It also works as new hardware on a renovation where the cabinetmaker is drilling fresh, since 3-3/4 inch centers appear in both frameless and face-frame cabinet programs. The 4-15/16 inch overall length keeps the pull proportional on mid-size drawers and upper door fronts without overrunning narrower stiles.
The pull is cast in zinc and finished in Brushed Satin Nickel. The brushed surface texture diffuses light rather than reflecting it, which keeps the hardware from competing with glossy surfaces nearby. Satin Nickel reads as a cool, neutral silver tone that coordinates with stainless appliances and chrome plumbing fixtures without demanding an exact match. In a transitional kitchen where the cabinetry mixes traditional proportions with cleaner lines, a brushed nickel pull sits comfortably in both directions.
This pull suits cabinet shops and contractors specifying hardware for a full kitchen or bath run, where consistent hole spacing across a large order matters. It also serves homeowners swapping out a dated finish across existing cabinetry drilled to 3-3/4 inch centers, since the spacing handles the fit and only the look changes. Designers specifying a transitional program will find the Asbury collection's companion pieces in the same series, allowing knobs on doors and pulls on drawers to draw from one coordinated design language.
Measure between the centers of the two existing holes on your door or drawer front. If that distance is 3-3/4 inches, this pull mounts without any new drilling.
Yes. The 3-3/4 inch spacing is cataloged as both 95 mm and 96 mm across different manufacturers. They refer to the same standard hole pattern, so this pull fits cabinetry drilled to either figure.
The Asbury collection includes companion knobs and additional pull sizes in the same design language and Brushed Satin Nickel finish, making it practical to run knobs on doors and pulls on drawers from one series.
Brushed Satin Nickel is a cool, muted silver tone that reads well alongside stainless steel, though finish appearances vary between manufacturers and a side-by-side comparison is the surest check.
When the cabinetry is already drilled to 3-3/4 inch centers, this Asbury pull in Brushed Satin Nickel changes the look of the room without touching the doors.
Sold In: 1 Each