Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Top Knobs Aspen II pull is a compact contemporary bar pull designed for cabinet doors and drawer fronts where the mounting holes sit just 7/8 inch (22 mm) apart.
The 7/8 inch center-to-center spacing is one of the narrowest hole patterns in cabinet hardware, and it is specific: it exists on small overlay doors, inset door applications, and older cabinetry drilled to a close European standard before wider bar pulls became the norm. When you are replacing hardware on a bank of doors already drilled at this spacing, there is no rerouting the holes without refinishing the front. A pull that matches the 22 mm pattern drops in without a trace of the swap. This one also works on frameless uppers and narrow filler drawers where a longer pull would visually overpower the front or physically conflict with adjacent hardware.
The pull is cast in zinc and finished in Polished Chrome. Chrome at this scale behaves differently than it does on a long appliance pull: the short, flat bar reflects as a single bright point rather than a running highlight, which gives even a small front a crisp focal detail. Polished Chrome is also one of the most coordination-friendly finishes in the kitchen because it reads as neutral against stainless appliances, chrome faucets, and most light fixture hardware already in the room. The flat 5/8 inch section keeps the profile close to the door face, so the pull adds clearance without adding bulk.
This pull suits designers and cabinet shops working on contemporary kitchens, baths, and built-ins where some fronts are drilled to a close 22 mm pattern and the hardware program needs to stay consistent across all of them. It is also the right answer for a homeowner replacing worn or mismatched hardware on an existing kitchen where the hole spacing is already set. Because it is part of the Aspen II collection, companion knobs and pulls in the same design language and finish are available for the rest of the installation.
The 7/8 inch (22 mm) center-to-center is the hole spacing, the distance between the centers of the two mounting holes. The 1-3/8 inch (35 mm) overall length is the end-to-end size of the pull including the posts. Every bar pull is longer than its hole spacing, so these two numbers are always different and should not be confused.
A polished surface shows fingerprints more readily than a brushed or matte finish and wipes clean just as easily. For high-traffic drawers where marks are a concern, a brushed chrome or satin nickel alternative may be worth comparing.
Yes. The Aspen II collection includes companion knobs in the same design language and Polished Chrome finish, which is the standard way to mix knobs on doors and pulls on drawers within one installation.
At 1-7/16 inches (37 mm), the pull stands further off the door face than its small footprint might suggest. Check that adjacent drawers or doors have enough clearance when both are open.
When the holes are drilled at 22 mm and the finish is chrome, this Aspen II pull resolves both constraints cleanly without compromise on either dimension.
Sold In: 1 Each