Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Top Knobs Aspen II pull is a contemporary bar pull for cabinet doors and drawer fronts, sized to mount on 7/8 inch (22 mm) centers — a tight spacing that suits smaller fronts, narrow drawers, and installations where a wider hole pattern would crowd the face.
Most cabinet pulls mount on 3 inch or 3-3/4 inch centers, which means a 7/8 inch pull occupies a completely different niche. At this spacing it is the right fit for small doors — upper cabinets with narrow stiles, spice pull-outs, appliance garage doors, and medicine cabinet fronts where a standard two-hole spacing would land one screw in the edge banding or split the rail. It also works cleanly on narrow drawer fronts where the geometry of the face simply will not accommodate a wider grip. If existing holes are already drilled at 7/8 inch, this pull drops onto them without any additional work.
The pull is cast in zinc and finished in Brushed Satin Nickel. The brushed surface diffuses light rather than reflecting it, which keeps the finish reading as a quiet silver tone instead of a bright one. That matters on small hardware: a polished finish on a compact pull can appear to float, while a brushed surface anchors the piece to the door face. Brushed Satin Nickel also coordinates across a wide range of kitchen and bath fixtures without the risk of a cross-brand mismatch that a named gold or bronze tone introduces. The squared bar section keeps the profile flat against slab and shaker fronts alike.
This pull is the practical choice for a designer or cabinet shop working through a kitchen with mixed front sizes — large drawer banks running a longer pull alongside narrow doors or pull-outs that need hardware on a much shorter hole pattern. Specifying from within the Aspen II collection means the knobs, pulls, and companion pieces all share the same design language and finish, so the hardware program stays coherent even when the hardware sizes do not. It is equally suited to a single-cabinet swap where the existing hole pattern is already at 7/8 inch and the homeowner wants a current, coordinated finish.
Narrow fronts — spice pull-outs, narrow filler doors, and some face-frame upper cabinets — do not have enough face width to accommodate a standard 3 inch or 3-3/4 inch hole pattern without placing a screw too close to the edge. A 7/8 inch spacing keeps both screws well within the safe zone on those narrower pieces.
Center-to-center is the drilling dimension — the 7/8 inch distance between the two hole centers. Overall length at 1-3/8 inches is the end-to-end size of the pull, which is always larger. Match existing holes to the center-to-center figure, not to the overall length.
No. Brushed Satin Nickel has a matte, directional texture that reduces glare and fingerprint visibility. Polished nickel is a mirror-bright surface. The two are different finishes with a noticeably different appearance in the same room.
Yes. The Aspen II series includes companion knobs and pulls in the same design language and finish, which makes it straightforward to run knobs on doors and this pull on narrow drawers without introducing a second hardware program.
When the front is narrow and the spacing is tight, this Aspen II pull in Brushed Satin Nickel delivers a clean, contemporary grip without compromise.
Sold In: 1 Each