Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Top Knobs Pennington bar pull is a contemporary steel cabinet pull for doors and drawer fronts, finished in Flat Black and drilled on 3-3/4 inch centers.
The 3-3/4 inch center-to-center spacing is one of the most widely drilled patterns in residential cabinetry. On an existing kitchen or bath where the holes are already there, this pull drops into place without touching a drill. On new work it drills to a standard template shared by most cabinet shops, which simplifies layout on a full run of drawers. The 4-3/8 inch overall length keeps the pull proportional to mid-size drawer fronts and upper door stiles without crowding the edges.
The bar is steel rather than the zinc alloy found on most pulls in this segment, which gives it noticeable density in the hand. Flat Black is a matte surface with no sheen, so the finish does not catch kitchen light or produce the hot spots a polished black would show. Against a light painted front the pull reads as a clean graphic line; against a dark or black front it settles into the cabinetry and stays quiet. The slender 1/2 inch width keeps the bar from drawing too much attention on a shaker or slab door.
This is a practical choice for cabinet shops running a standard 3-3/4 inch template across a full kitchen, and for homeowners replacing existing hardware on a common hole pattern without drilling new holes. Designers specifying a contemporary kitchen in a black hardware program will find the Flat Black finish and narrow bar profile suited to flat-front and shaker cabinetry alike. Because it belongs to the Top Knobs Bar Pulls series, coordinating pieces in the same design language are available for wider drawers or taller pantry fronts where a longer center-to-center spacing is needed.
Flat Black is a matte finish with no reflective sheen, unlike a polished or lacquered black surface.
Steel is denser than the zinc alloy used on most cabinet pulls, so it feels heavier and more solid in the hand at the same size.
The pull mounts on 3-3/4 inch centers. The standard 96 mm spacing and this 95 mm value are the same industry spacing encoded two ways, so it seats on existing 96 mm holes without any modification.
The Top Knobs Bar Pulls series includes other center-to-center sizes and companion hardware in the same design language and Flat Black finish.
This pull is built around the spacing most cabinets already have and finished in a matte black that stays consistent whether the light is bright or low.
Sold In: 1 Each