Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Top Knobs Amwell bar pull is a contemporary steel bar pull for cabinet doors and drawer fronts, designed to mount on one of the most widely drilled hole patterns in residential cabinetry.
The 3-3/4 inch center-to-center spacing is the hole pattern that shows up most often on factory-built cabinetry, which makes this pull a natural candidate for a straightforward hardware refresh. If the existing pulls on a run of base drawers or upper doors are already drilled to this spacing, the Amwell drops onto those holes without any new drilling. That is a meaningful advantage on a full kitchen swap, where saving a drilling step on every front adds up quickly. It also suits new construction where the shop is running a standard hole pattern across the job.
The pull is made from steel, which gives it more mass in the hand than the plated zinc found on most hardware in this category. Flat Black is a matte, non-reflective finish: it absorbs light rather than bouncing it, so the pull holds its color evenly across the front without picking up hot spots under kitchen or bath lighting. Against white or light painted fronts it reads as a sharp graphic line. Against dark fronts it recedes and lets the cabinetry carry the room. The slim 1/2 inch bar section keeps that line narrow, so the hardware stays in proportion on a standard drawer or door face without competing with the joinery.
Cabinet shops running a contemporary program in black hardware will find this pull easy to order in quantity and easy to install without custom drilling. Designers specifying a full kitchen in a flat black palette can coordinate pulls on drawers with companion pieces from the same Bar Pulls series, keeping the finish and design language consistent across doors and drawers. Homeowners replacing existing hardware on a standard-drilled cabinet run can treat this as a drop-in replacement, provided the existing hole spacing is confirmed at 3-3/4 inches center-to-center. It suits slab, shaker, and flat-panel door styles equally, because the bar profile does not borrow from any particular historical design language.
Many factory-built cabinets are drilled at 3-3/4 inch centers, which matches this pull. Measure between the centers of your existing holes before ordering to confirm the spacing.
Flat Black is a low-sheen, non-glossy surface that does not reflect light. The exact application method is not specified in the source data, but the visual result is a matte, even black rather than a lacquered or polished one.
Yes. The Bar Pulls collection from Top Knobs includes companion pieces designed to coordinate in the same finish and design language, which is the practical way to run pulls on drawers and knobs on doors within one project.
Steel tends to feel denser and more substantial underhand than die-cast zinc. The difference is most noticeable on a bar pull where the grip contacts the full width of the bar.
When the hole pattern is already there and the finish needs to be flat black, this Top Knobs bar pull closes the gap between the existing drilling and the hardware the room calls for.
Sold In: 1 Each