Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Top Knobs TK Series bar pull mounts on 3-3/4 inch centers, one of the most widely drilled hole spacings in production cabinetry, and finishes in Brushed Satin Nickel over a steel base.
The 3-3/4 inch center-to-center is the go-to spacing for upper cabinet doors, mid-width drawers, and bath vanity fronts across most production cabinet lines. When a shop or a homeowner is replacing hardware across an entire kitchen drilled to this spacing, the mounting holes are already there. This pull drops onto that pattern without touching a drill. For new installs, it is also the spacing most cabinet door fronts are factory-drilled to, which reduces layout time on a multi-door run.
The pull is constructed from steel, which gives it a solid feel relative to zinc-bodied pulls of similar dimensions. The Brushed Satin Nickel finish is a mid-sheen silver-toned surface: less reflective than polished chrome, warmer and lighter than matte black. It keeps fingerprints less visible than a high-polish finish and coordinates naturally with stainless appliances, brushed nickel faucets, and other satin-finish fixtures already present in most kitchens and baths. At 1/2 inch wide, the bar reads as a fine line across the door rather than a prominent horizontal element.
This is a practical pick for cabinet shops ordering hardware for a full kitchen where nearly every opening is drilled to the standard 3-3/4 inch pattern. It is equally useful for a homeowner refreshing dated hardware without redrilling, or a designer specifying contemporary hardware across a bath vanity. The Brushed Satin Nickel finish makes it a low-conflict choice in spaces that already run silver-tone fixtures, and the clean bar profile keeps the hardware from competing with the cabinetry's door style or color.
The pull measures 4-3/8 inches (111 mm) end to end. The 3-3/4 inch figure is the center-to-center hole spacing, which is always smaller than the overall length.
Yes. The 3-3/4 inch (95 mm) center-to-center spacing is one of the most common factory-drilled patterns in production cabinetry, so it fits a wide range of existing installations without modification.
Brushed Satin Nickel has a softer, lower-sheen surface than Polished Nickel. It shows fewer fingerprints and reflects less light, which suits kitchens and baths where the hardware should complement rather than stand out.
The Bar Pulls collection from Top Knobs includes companion knobs and other pieces in the same design language. Mixing pulls on drawers with knobs on doors from the same series and finish is the standard way to coordinate a full cabinet program.
For cabinetry drilled to the 3-3/4 inch standard, this Top Knobs bar pull in Brushed Satin Nickel is a direct, no-modification replacement that keeps the hardware program clean and consistent.
Sold In: 1 Each