Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Top Knobs Pennington bar pull is a contemporary steel pull for cabinet doors and drawer fronts, mounting on 3 inch (76 mm) centers and finished in Oil Rubbed Bronze.
The 3 inch center-to-center spacing is the right call for narrow cabinet doors and smaller drawer fronts where a longer pull would visually crowd the front. Spice drawers, upper cabinet doors, medicine cabinet doors, and bathroom vanity drawers are all natural placements for this spacing. On a narrow shaker-style door it sits centered and proportionate; on a small utility drawer it leaves room on either side of the pull without bumping into edge banding or door overlay. Because 76 mm is a standard drilling increment, this pull also drops onto an existing hole pattern without additional layout work on a replacement job.
The pull is constructed from steel and finished in Oil Rubbed Bronze, a hand-applied, darkened bronze tone with subtle variation across the surface. Unlike a uniform plated finish, Oil Rubbed Bronze reads as a worked, warm metal that softens the line of a bar pull rather than sharpening it. The finish pairs naturally with aged or antique brass fixtures in a traditional kitchen and holds contrast against cream, off-white, or gray painted cabinetry without demanding attention. Because the finish is steel-based rather than zinc, the bar carries a noticeable solidity relative to its slim 1/2 inch cross-section.
This pull suits a contemporary or transitional kitchen, bath, or built-in where the hardware program runs in bronze tones and the fronts include a mix of smaller doors and narrow drawers. It is particularly well matched to a project where pulls on drawers need to coordinate with knobs or companion pulls on doors from the same Top Knobs Bar Pulls series, since finish and profile consistency across that series is how a mixed hardware program holds together visually. Cabinet shops specifying hardware across a full kitchen, designers building out a bronze-toned fixture program, and homeowners replacing narrow-drawer pulls on a standard 3 inch hole pattern will all find this a direct-fit solution.
Drill on 3 inch (76 mm) centers, measured between the centers of the two mounting holes. The pull measures 3-3/8 inches end to end, so the overall length is slightly longer than the spacing.
Oil Rubbed Bronze is a finish with intentional surface variation, so individual pieces may show subtle differences in tone. Pieces from the same production run will be closer in appearance than pieces ordered at different times.
Yes. The Bar Pulls series from Top Knobs is available in multiple center-to-center sizes and companion knobs in the same Oil Rubbed Bronze finish, which is the standard way to coordinate pulls on drawers with knobs on doors in one kitchen.
The 3 inch spacing is a common fit on vanity drawers and single-door vanity cabinets where a longer pull would be oversized for the front. The Oil Rubbed Bronze finish is an indoor finish; it is not rated for wet or exterior exposure.
Choose this pull where the hardware needs to land on 3 inch centers in Oil Rubbed Bronze without breaking the finish or profile line established by the rest of the Top Knobs Bar Pulls series.
Sold In: 1 Each