Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Top Knobs Hopewell bar pull is a contemporary steel pull for wide cabinet drawers, pantry doors, and oversized drawer fronts, mounting on 18-7/8 inch (480 mm) centers.
A pull at this center-to-center is a deliberate choice, not a default one. At 480 mm between mounting holes, this bar is sized for the widest drawers in a kitchen — the deep pot drawers, the wide spice banks, the full-width base drawers under a cooktop. It also suits the tall, narrow pantry doors and appliance garage fronts that run taller than wide and need a grip the hand can find without looking. On a standard 30-inch-wide door, a pull of this length anchors the front visually in a way a 128 mm or 160 mm pull simply cannot. The 21-3/4 inch overall length carries enough visual weight to balance large slab and shaker fronts without competing with the cabinetry itself.
The pull is made from steel rather than the zinc alloy common across much of this category, which gives the bar a slightly denser feel underhand. The Brushed Satin Nickel finish is applied over that steel substrate, producing a cool silver tone with a directional brush that diffuses kitchen light instead of throwing it back. Because the sheen is consistent and low-key, this finish tends to stay readable in both warm and cool lighting environments. The flat 15/32 inch bar width keeps the profile tight and linear — it reads as a single horizontal or vertical element on the front rather than as a sculptural object.
Designers specifying a contemporary kitchen in Brushed Satin Nickel reach for a pull at this scale when the front is too wide for a shorter bar to look intentional. Cabinet shops installing wide pot-drawer banks in production kitchens use it because the 480 mm hole spacing is consistent with the wide-format drawer construction already in the build. Homeowners replacing hardware on an existing pantry door or island drawer bank with holes drilled at this spacing find it a direct, no-measurement-required replacement. It fits naturally in kitchens running a silver-tone hardware program, where it coordinates with faucets, appliances, and light fixtures already in place — though finish coordination across brands is always a matter of on-site comparison rather than assumption.
Center-to-center — 18-7/8 inches (480 mm) — is the distance between your two mounting holes. Overall length — 21-3/4 inches (552 mm) — is the end-to-end size of the pull including the posts. Drill or match your holes to the center-to-center figure.
Steel. The Material Type for this SKU is steel, which is less common in this category than zinc alloy and gives the bar a slightly different weight and rigidity.
Within the Top Knobs Bar Pulls series, companion pieces carry the same Brushed Satin Nickel finish designation. Across different brands, finish names may look similar but are produced by different processes and may not be a visual match side by side.
The pull stands 1-7/16 inches (37 mm) out from the face of the door or drawer front, which is the finger clearance between the cabinet face and the back of the bar.
When the cabinetry is wide enough that a shorter pull would look incidental, this 18-7/8 inch Brushed Satin Nickel bar pull gives the front the horizontal or vertical line it needs to read as finished work.
Sold In: 1 Each