Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Top Knobs Hopewell bar pull is a contemporary surface-mount pull for wide cabinet drawers and oversized door fronts, mounting on 30-1/4 inch (768 mm) centers.
A center-to-center measurement of 30-1/4 inches is at the far end of the cabinet pull spectrum, and the fronts that need it are specific: full-height pantry doors, wide pot-and-pan drawers, bank drawers on a furniture-style island, and oversized panel fronts where hardware at a shorter spacing would read as undersized. At this scale the pull is not just a grip, it is a strong horizontal element that anchors the front visually. A slim bar profile at this length keeps the emphasis on the line itself rather than on the hardware mass.
The pull is built on a steel bar rather than the zinc die-cast found on most pulls in this category. Steel carries more inherent rigidity across a long unsupported span, which matters when the grip is nearly 33 inches end to end. The Honey Bronze finish gives the bar a warm amber-gold tone with moderate sheen, closer to a classic brass reading than a bright gold or a flat bronze. On natural wood cabinetry it coordinates with the grain tones. On painted fronts it introduces warmth against white, gray, or sage. Because Honey Bronze is a finish applied over steel, it is a surface treatment and color, not a metal composition.
Cabinet shops building furniture-style islands, designers specifying full-height pantry hardware, and remodelers replacing a single wide-drawer pull that was already drilled at 768 mm are the buyers for this SKU. At 30-1/4 inch centers, very few pulls in any catalog reach this spacing, which means this is often a decision driven by existing holes rather than a fresh layout. If the cabinetry is being built new, this length suits a design intent where the hardware runs the full width of the drawer to align flush with the front's edges. The contemporary design style and the slender bar width make it compatible with slab, flat-panel, and shaker doors alike.
It is not a common spacing for smaller cabinetry, but it is used on wide base drawers, full-height pantry doors, and furniture-style pieces where the hardware is meant to run the full width of the front. If you are replacing existing hardware, measure between the centers of your current holes to confirm 30-1/4 inches before ordering.
Overall length is 33 inches, which leaves about 1-1/2 inches of front visible beyond each end of the pull on a 36 inch front. The mounting holes fall at 30-1/4 inches apart, centered on the front. Whether that proportion works is a design choice, not a fit constraint.
Honey Bronze is a warm amber-gold with moderate sheen. It reads warmer than Satin Brass and brighter than most Antique Brass finishes. Because finish appearance varies by manufacturer and lighting, it is best to view a physical sample alongside any existing hardware before specifying across a full kitchen.
The Top Knobs Bar Pulls series is available across a range of center-to-center sizes in Honey Bronze, so companion pieces at shorter spacings can be sourced from the same collection and finish.
When the drawer or door is wide enough that shorter hardware would look mismatched, this pull provides the span, the finish, and the profile to carry the front correctly.
Sold In: 1 Each