Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Top Knobs TK Series pull is a steel bar pull spanning 30-1/4 inches center-to-center, sized for tall pantry fronts, wide drawer banks, and appliance-scale cabinetry where a standard-length pull would read as undersized.
A 30-1/4 inch center-to-center spacing puts this pull in a specific category of hardware decisions. At this length, the intended home is a tall pantry door, a wide refrigerator-panel surround, or an oversized drawer bank on a kitchen island. It is also used on furniture-scale pieces where the front runs 36 inches or wider and a shorter pull would look like an afterthought. The pull runs nearly the full width of a standard 33-inch base cabinet, so it makes a clear horizontal statement across the face rather than accenting one corner of it. For designers working on the principle that pull length should track front width, this is the answer for the largest fronts in the kitchen.
The bar section is steel, which gives the long span enough stiffness to resist any flex under use without adding visible bulk. The profile is a slender 1/2 inch wide, so the length reads as a clean line rather than a heavy rail. Brushed Satin Nickel is a matte-silver finish that diffuses light instead of reflecting it, keeping the surface calm rather than bright. It coordinates well with stainless appliance fronts and sits comfortably alongside nickel faucets and fixtures without demanding an exact match. The finish belongs to the Silver Tone family, making it straightforward to pull companion pieces from the same color range across the kitchen.
Cabinet shops and designers working on full kitchens with a pantry column or a bank of deep drawers are the most common buyers for this length. A contractor fitting out a modern kitchen with slab fronts and minimal hardware will reach for this pull when the client wants the hardware to read as architecture rather than as ornament. Homeowners replacing hardware on a pantry door or a tall utility cabinet will find that this length delivers scale to a front that shorter pulls cannot. Because it belongs to the Top Knobs Bar Pulls series, companion pieces in the same series and finish are available for doors and smaller drawers throughout the same project.
Center-to-center is the distance between the two mounting holes: 30-1/4 inches (768 mm). That is the number to match to your existing holes or your layout. Overall length is 30-5/8 inches end to end, which is the dimension that governs how much of the front the pull spans visually.
Yes. At this length, steel resists flex more effectively than a cast zinc bar of the same profile, which is one reason this series uses steel for its longer center-to-center options.
Brushed Satin Nickel is a silver-tone finish that reads close to brushed stainless in most lighting, though finish-to-finish matches across manufacturers are never guaranteed. It tends to blend well rather than conflict.
Yes. A pull of this length is used on tall pantry fronts and large door panels as often as it is on wide drawers. The mounting method is the same two-hole installation regardless of the front type.
Choose this pull when the front is wide enough that the hardware should span it rather than sit in the middle of it. The 30-1/4 inch center-to-center in Brushed Satin Nickel delivers that proportion across pantry doors, island drawers, and oversized cabinetry without adding visual weight to the room.
Sold In: 1 Each