Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Top Knobs Amwell bar pull is a contemporary steel pull designed for wide drawer fronts, pantry doors, and oversized cabinet panels where a standard-length pull would look undersized against the front.
A 30-1/4 inch center-to-center pull is not everyday cabinet hardware. It is scaled for the widest fronts in a kitchen or closet build: wide four- and five-drawer base units, full-height pantry doors, appliance garage panels, and island drawers that span the full cabinet width. At this spacing, the pull becomes a horizontal element in the room rather than a detail on a single front. It draws a consistent line across an entire bank of cabinetry when repeated, which is why specifiers reach for a pull at this length when continuity across wide runs matters as much as the hardware itself.
The pull is built from steel and finished in Ash Gray, a cool mid-tone that sits between a true silver and a flat gray without reading as either. On light cabinetry it holds contrast without going as stark as matte black. On dark or painted fronts it softens the transition between cabinet and hardware. The slim 1/2 inch bar profile keeps the footprint minimal: even at over 30 inches in length, this pull does not dominate the door face so much as it defines it. The contemporary profile suits slab and flat-panel fronts where the geometry of the hardware should echo the geometry of the door.
Cabinet shops and designers specifying full-height pantry columns or wide island bases find this length useful when they want the hardware to span most or all of the front rather than sit centered on it as a smaller accent. Contractors working on contemporary kitchens with wide lower cabinetry can run this pull consistently across a base run for a uniform horizontal line at drawer height. Homeowners replacing hardware on an existing wide drawer bank drilled to 768 mm centers will find this a direct match. Because it belongs to the Bar Pulls collection, companion pieces at shorter center-to-center spacings exist in the same finish and profile for narrower fronts in the same installation.
The 30-1/4 inch (768 mm) figure is the distance between the centers of the two mounting holes — the number you match to your existing holes or use to mark new ones. The 30-5/8 inch (778 mm) overall length is how long the pull is end to end, which governs clearance on the front. Always drill to the center-to-center measurement, not the overall length.
Ash Gray is a factory finish applied over the steel substrate. It is not a chrome plate or a polished surface — it reads as a flat, cool gray tone with a low sheen.
Yes. At this length it is commonly used on tall pantry doors and full-height cabinet fronts, not just wide drawers. The bar orientation — horizontal on a drawer, vertical on a door — is a design choice.
The Bar Pulls collection by Top Knobs includes this pull at multiple center-to-center spacings in the same Ash Gray finish, so narrower fronts in the same installation can use a matching pull at a proportionate length.
At 30-1/4 inches on center, this Ash Gray bar pull is the right hardware when the front is wide enough that smaller pulls would simply disappear against it.
Sold In: 1 Each