Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Top Knobs TK Series M2630 is a flat bar pull for cabinet doors and drawer fronts, mounting on 5-1/16 inch (128 mm) centers in a Flat Black finish.
The 128 mm center-to-center is the standard spacing for mid-range drawer fronts and upper cabinet doors. It is wide enough to give a confident grip on a two-panel door without overpowering a moderately sized drawer. In a kitchen that mixes knobs on doors with pulls on drawers, this is the size that tends to land on the bank of base drawers that gets the most daily use. The 5-7/16 inch overall length gives a small visual buffer on either side of the hole centers, so the pull reads proportionate on a front that ranges anywhere from about 10 to 18 inches wide.
The pull is made from steel, which has a denser, less die-cast feel in the hand than the zinc-alloy hardware that makes up most of this category. Flat Black is applied as a matte surface with no sheen, which means it absorbs light rather than reflecting it. That behavior is what separates a flat finish from a matte black that still carries some polish: there is no highlight line running along the bar under a kitchen pendant or recessed fixture. On a light-colored cabinet front the pull registers as a strong graphic element; on a dark front it settles into the surface. Either way it does not compete with the cabinetry for attention.
This is a practical choice for a contemporary kitchen, a modern bath vanity, or a built-in where the hardware program is black and the cabinet fronts are flat or shaker-style. The 128 mm spacing makes it easy to source companion hardware for other drawer widths within the same Bar Pulls collection, so a cabinet shop or designer running multiple sizes across a project can keep the same finish and profile family without mixing manufacturers. It also suits a straightforward replacement job where the existing holes are already drilled to 128 mm centers.
Flat Black, as used here, is the manufacturer's specific finish name for this pull. Finish names are not standardized across brands, so treat Flat Black as the identifier for this SKU rather than a generic descriptor.
The steel here is the pull body, not the door or drawer front. Mounting goes through the cabinet front from behind, so the pull material is not what you are drilling through.
Yes. The TK Series Bar Pulls collection spans a range of center-to-center spacings, all available in the same finish family, so you can run consistent hardware across drawer banks of different widths.
Yes. The flat bar profile and Flat Black finish are a common pairing with shaker fronts, whether on a door or a drawer, because the clean rectangular section follows the same geometry as the stile-and-rail frame.
When the hole pattern is already 128 mm and the finish program is black, this pull closes the job without introducing a second design language or a second metal to the room.
Sold In: 1 Each