Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Top Knobs Hopewell bar pull is a contemporary steel cabinet pull for doors and drawer fronts, centered on the 5-1/16 inch (128 mm) hole spacing that suits a wide range of mid-width cabinetry.
At 5-1/16 inches between centers, this pull sits at a spacing that bridges the gap between the compact 96 mm pulls common on narrow drawers and the longer reaches used on wide drawers and appliance fronts. It is a natural fit for upper cabinet doors, mid-depth drawer banks, and base cabinets where a 3-3/4 inch pull would feel undersized and a 6-5/16 inch pull would feel like a reach. The 7 inch overall length gives the hardware visual weight proportional to those fronts without crowding a door with a narrow stile. For a shop specifying across a mixed cabinet run, this is the spacing that works on a range of fronts without requiring a second pull size.
The Hopewell pull is made from steel, which gives it a denser feel in the hand than the zinc construction common across much of this category. Flat Black is a matte finish: no gloss, no sheen, and no reflective surface to read under overhead lighting. On a light-colored front the pull delivers strong graphic contrast. On a dark front it settles into the door rather than separating from it. The narrow 15/32 inch bar section keeps the silhouette tight and linear, so the finish does the visual work while the profile stays quiet.
This is the right pull for a contemporary kitchen or bath renovation where the hardware program is already committed to black and the cabinetry is flat-fronted. It suits designers specifying a cohesive hardware package across upper doors and drawer banks, cabinet shops pre-sourcing for a spec build, and homeowners replacing an existing set drilled to 128 mm centers. The Hopewell pull belongs to Top Knobs' Bar Pulls series, so companion pieces in the same design language and finish are available within the collection for mixing knobs on doors with pulls on drawers.
Yes. 5-1/16 inches converts to 128 mm, and the two values describe the same hole spacing. Either measurement can be used when drilling or matching existing hardware.
Steel. That is less common across cabinet pulls in this finish category and gives the pull a noticeably solid feel compared to zinc-cast alternatives.
Flat Black on this pull is a matte surface with no gloss. The source does not specify the application method, so the finish is best described by its appearance: even, low-sheen, and consistent across the bar.
Yes. Bar pulls of this size are commonly used on both. The 128 mm center-to-center spacing and 7 inch overall length are proportioned to work on mid-width drawers and standard door fronts.
When the hardware needs to land on doors and drawers alike in a flat black matte finish, the 5-1/16 inch Hopewell pull handles both without requiring a second size on the order.
Sold In: 1 Each