Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Top Knobs Barrington pull is a contemporary bar pull for cabinet doors and drawer fronts, mounting on 5-1/16 inch (128 mm) centers and finishing in Brushed Satin Nickel.
The 5-1/16 inch (128 mm) center-to-center spacing sits at a practical crossroads in cabinet hardware. It is common enough that many kitchen and bath cabinets arrive pre-drilled at this spacing, which makes this pull a direct drop-in on a remodel or a refresh without picking up a drill. At the same time, it is wide enough to suit a drawer that would look undersized with a 96 mm pull. Base cabinet drawers in the 15 to 24 inch range, wall cabinet doors, and vanity drawer fronts all fall in the zone where this spacing makes visual and functional sense. Because it mounts across two holes nearly an inch further apart than the more common 3-3/4 inch pulls, it anchors more securely to the front and stays planted during repeated daily use.
The pull is cast in zinc and finished in Brushed Satin Nickel. The brushed surface texture diffuses light across the bar rather than reflecting it in a sharp line, which keeps the hardware from competing with the cabinetry for attention under kitchen or vanity lighting. Satin Nickel sits in the silver tone family without the cold sharpness of polished chrome, which is why it integrates easily with stainless appliances, brushed faucets, and light fixtures already in the room. The 5/16 inch bar width is narrow enough that the pull reads as a line rather than a shape, reinforcing the contemporary geometry without adding visual weight.
This pull is well matched to a contemporary or transitional kitchen or bath where the hardware should coordinate with other silver-toned fixtures rather than introduce a new metal. It works equally well for a cabinet shop specifying hardware across a full run of cabinetry and for a homeowner replacing a single bank of drawers to match an existing hole pattern. The Barrington collection spans multiple centers and formats, so a project that mixes pulls on wide drawers with knobs on doors and a larger appliance pull on the pantry can draw all three from the same series.
Yes. This pull mounts on 5-1/16 inch (128 mm) centers. If your existing holes measure 128 mm between centers, it is a direct replacement.
The projection is 1-3/16 inches (30 mm), measured from the door face to the back of the grip.
Brushed Satin Nickel is a silver-toned finish that reads close to brushed stainless in most lighting. Cross-material coordination depends on the specific appliance finish, so compare samples where an exact match matters.
The Barrington collection includes companion knobs, pulls at other centers, and appliance pulls in the same design language and finish, so you can draw the full hardware program from one series.
When the hole pattern is already at 128 mm and the room calls for a silver tone, this Barrington pull resolves both requirements in one SKU without compromise.
Sold In: 1 Each