Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Top Knobs Channing cup pull is a cabinet drawer pull from the Barrington collection, mounting on 2-3/4 inch (70 mm) centers and finished in Polished Nickel over zinc.
Most cup pulls in this catalog are drilled at 3-3/4 inch (96 mm) or wider centers, which suits mid-to-large drawer fronts. The 2-3/4 inch (70 mm) spacing here addresses the narrower end of the drawer bank: a 12-inch spice drawer, a slim utensil pull-out, a jewelry drawer in a vanity, or a small built-in beside an appliance. On a front of that width a longer pull would extend almost edge to edge, leaving no visual margin. At 70 mm centers, the 4-1/4 inch overall length sits with breathing room on both sides. For a shop or a designer running a mix of drawer widths off a single series, this center-to-center value is what makes the narrow fronts work.
The pull is cast in zinc and finished in Polished Nickel, a bright, cool-toned silver that reflects light evenly across the curved surface of the cup shell. Polished finishes pick up highlights more readily than brushed ones, so this pull will read as a small gleam on the drawer face rather than a quiet accent. That makes it a natural fit alongside chrome faucets, stainless appliances, and other polished silver-tone fixtures in the kitchen or bath. Within the Barrington collection, the same Polished Nickel finish runs across companion knobs and additional pull sizes, so the hardware program can stay consistent across every front in the room.
This pull is the right choice for a kitchen, bath, or custom built-in where at least some of the drawer fronts are narrower than a standard base cabinet, and where the hardware program calls for a polished silver tone. It suits a contemporary design direction without being aggressive about it — the cup form has traditional roots, and Polished Nickel sits comfortably in both transitional and contemporary kitchens. Cabinet shops assembling a full hardware spec across a range of drawer widths will find this spacing fills the gap the standard 96 mm pull cannot. Homeowners replacing individual pieces in an existing Barrington installation can match the series directly.
The 2-3/4 inch (70 mm) center-to-center is well suited to narrower fronts, typically in the 9 to 14 inch range, where a 3-3/4 inch or longer pull would leave too little margin on either side. Sizing hardware to roughly a third of the front width is a common design practice, though it is a preference rather than a requirement.
Yes. A cup pull has an up and a down: the open shell faces outward and the hand reaches in from below. Install it with the opening facing down so the grip is natural and the shell does not collect debris.
A polished surface shows marks more readily than a brushed finish and wipes clean just as easily with a soft cloth.
The Barrington collection coordinates within the same finish. Two manufacturers' finish names that sound similar are not guaranteed to match, so stay within the same series and finish for a consistent look.
When the narrow drawers in a cabinet run need their own pull, the 2-3/4 inch center-to-center keeps the Barrington collection consistent from the widest base to the smallest built-in.
Sold In: 1 Each