Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Top Knobs Chareau pull is a contemporary cabinet pull mounting on 8-13/16 inch (224 mm) centers, sized for wide drawer fronts, full-height pantry doors, and oversized base cabinet doors where a shorter pull would look undersized and underbuilt.
The 8-13/16 inch center-to-center is a wide spacing, and that is exactly the point. Wide drawers, tall pantry fronts, and appliance-adjacent base cabinets are the fronts where a 3-3/4 inch or 5 inch pull sits dwarfed by the face it is mounted on. At 224 mm centers this pull reaches far enough across those wide surfaces to look intentional rather than afterthought. It is also a practical replacement spec: if an existing wide drawer bank is already drilled at this spacing, this pull drops onto those holes without any additional work.
The pull is cast in zinc and finished in Brushed Satin Nickel. The brushed surface runs a fine texture across the bar that diffuses light rather than reflecting it, keeping the silver tone soft and even under kitchen and bath lighting. Satin Nickel is one of the most widely used finish names in residential hardware, and within the Chareau collection the companion knobs, backplates, and pulls carry the same Brushed Satin Nickel designation, which is the reliable way to coordinate within a series. Cross-brand Satin Nickel from another manufacturer is a separate finish and may not read as a match.
Cabinet shops and designers specifying a contemporary kitchen with wide lower drawers will find this pull sized correctly for those fronts without stepping up to the appliance-pull scale. Contractors handling a renovation where the existing hole spacing is already at 224 mm can source a direct replacement with a current finish and a clean profile. Homeowners assembling a mixed hardware set in the Chareau collection can use this pull on wider drawers and pair it with Chareau knobs on doors, staying within one series for a consistent look across the full run of cabinetry.
The center-to-center spacing is 8-13/16 inches (224 mm). That is the dimension to measure between the centers of your existing holes, or to mark when drilling new ones.
The projection is 1-13/16 inches (46 mm) from the door or drawer face to the back of the bar, which is enough clearance for a full-hand grip on a wide drawer pull of this size.
Not reliably. Each manufacturer produces its own version of Satin Nickel, and the surface texture and tone vary between them. For a consistent match, stay within the Chareau collection.
Yes. At this center-to-center and overall length, it works on a wide drawer front or a full-height door where the scale of the hardware should match the scale of the face.
When the front is wide enough to demand serious hardware, this Chareau pull delivers the center-to-center spacing, the projection, and the Brushed Satin Nickel finish to meet it.
Sold In: 1 Each