Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Top Knobs Chareau series pull is a traditionally styled D-profile pull for cabinet doors and drawer fronts, mounting on 6-5/16 inch (160 mm) centers.
The 6-5/16 inch center-to-center spacing puts this pull in a range that suits wide base drawers, double-door wall cabinets, pantry fronts, and furniture-scale islands where a shorter pull would look proportionally light. At 160 mm it is one of the standard spacings stocked across the industry, which matters most when this is a replacement job: existing holes drilled to this spacing take this pull directly, with no new drilling required. The D-profile arc gives the grip a slightly more generous feel in the hand than a straight bar at the same projection, which is part of why this form shows up on heavier cabinetry.
The pull is cast in zinc and finished in Polished Nickel. Unlike a brushed nickel, which scatters light across a textured surface, polished nickel reflects cleanly and reads as a bright line along the arc of the D. That reflectivity makes it a natural companion to chrome plumbing fixtures and polished hardware elsewhere in a kitchen or bath, though the two are not the same finish and will read slightly differently side by side under natural light. The traditional design style of the Chareau series suits raised-panel and inset door programs as well as transitional kitchens where the hardware anchors the room to a warmer, more formal aesthetic.
This pull is a practical choice for a kitchen or bath renovation where the drawer fronts are wide enough to call for 160 mm hardware, the door program is traditional or transitional, and the finish runs bright rather than matte or brushed. Cabinet shops building furniture-style islands or hutch pieces will recognize the D-profile as the right grip form for a piece that needs to read as furniture rather than as built-in cabinetry. Designers specifying a full kitchen can coordinate knobs on door fronts with this pull on drawers, drawing from the Chareau collection to keep the series consistent across the room.
Center-to-center, 6-5/16 inches (160 mm), is the distance between the centers of the two mounting holes and is the number to match when replacing existing hardware. Overall length, 6-7/8 inches (175 mm), is the full end-to-end size of the pull and determines how much of the front it covers visually.
Both are bright, reflective finishes, but they are not identical. Polished nickel typically reads slightly warmer and softer than polished chrome under most lighting. They can coordinate well in a room, but they are not an exact match.
No. It mounts the same way as a straight bar pull, through two holes at the stated center-to-center spacing. The arc of the D affects grip feel and visual profile, not the drilling pattern.
Yes. The Chareau collection includes companion pieces in the same series and finish, designed to coordinate when knobs are used on doors and pulls on drawers.
When the drawer bank is wide, the door fronts are tall, and the hardware should read as traditional and bright, this pull covers all three requirements at once.
Sold In: 1 Each