Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Top Knobs Dakota pull is a traditional-style cabinet pull that mounts on 5-1/16 inch (128 mm) centers, a spacing sized for mid-width drawers and standard upper cabinet doors.
The 5-1/16 inch center-to-center is not the entry-level spacing or the oversized one. It sits between the common 4 inch pull and the longer appliance-scale sizes, which makes it the natural fit for a drawer front in the 15 to 24 inch width range or an upper cabinet door where a 3-3/4 inch pull reads too small but a 6-5/16 inch pull would crowd the edges. If the existing hardware is already drilled to 128 mm, this pull drops onto those holes with no new drilling required.
The pull is cast in zinc and finished in Polished Chrome. Polished Chrome is a high-sheen, cool-toned finish that reflects light clearly along the length of the grip. On a traditional-profile or beaded-inset door it reads crisp against a painted or stained surface, and it ties naturally to chrome faucets, light fixtures, and appliance trim already in the room. Because the surface is polished rather than brushed, marks are visible and wipe off just as easily. The zinc body holds the finish evenly across the angle of the grip and the posts.
This is a pull for a traditional or transitional kitchen, bath, or built-in where the hardware program is chrome and the cabinetry has some profile or detail to it. A raised-panel door or a beaded inset front gives the traditional design language of the Dakota series something to work with. The 5-1/16 inch spacing also appears frequently in renovation work, so this pull is a practical replacement candidate on any existing installation drilled to 128 mm centers. Designers assembling a full hardware program can run this pull on drawers and pair Dakota knobs on doors to carry the same collection through the entire room.
Yes. 5-1/16 inches converts to 128 mm, and the two values describe the same hole spacing. Drill or measure to either figure and the pull will fit.
The projection is 15/16 inch (24 mm), measured from the door face to the back of the grip.
Yes. This spacing suits both mid-width drawers and standard upper cabinet doors. The 6-7/8 inch overall length is appropriate for either application.
The Dakota collection includes knobs in the same series. Confirm the finish name on those records before ordering to make sure they carry the same Polished Chrome value.
Choose this pull when the project calls for a 128 mm center-to-center in Polished Chrome and the room already speaks a traditional design language.
Sold In: 1 Each