Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Top Knobs Dakota Series pull is a traditional bar-style pull for cabinet doors and drawer fronts, mounting on the standard 3-3/4 inch center-to-center spacing found across the widest range of existing cabinetry.
The 3-3/4 inch center-to-center dimension is the single most reproduced hole pattern in cabinet manufacturing. A pull on this spacing will drop directly onto existing holes in the widest range of base cabinets, wall cabinets, and drawer banks without any new drilling. That makes it the practical choice for a hardware refresh where the goal is to update the finish without touching the door fronts. It also sits comfortably on mid-width drawers and standard-size doors where the hardware should feel present but not oversized.
The pull is cast in zinc and finished in Polished Chrome. Chrome at this level of polish acts as a mirror across the grip, picking up whatever light source is nearest and running it along the bar as a bright streak. In a kitchen it naturally picks up overhead task lighting, which makes the hardware visible and readable from across the room. It coordinates readily with chrome faucets, appliance trims, and light fixtures without requiring a finish match decision, because polished chrome is one finish category that reads consistently across manufacturers. The zinc base gives the pull solid dimensional stability and holds the finish reliably through normal daily use.
This pull suits a traditional or transitional kitchen, bath vanity, or built-in where the hardware program is chrome and the hole pattern is already drilled to 3-3/4 inches. Cabinet shops doing production runs on traditional face-frame kitchens will find this spacing built into their drilling jigs as a default. Homeowners refreshing dated hardware find it removes the need to measure twice: if the old pull was a standard residential size, this one lands on the same holes. Designers specifying a kitchen that already runs polished fixtures throughout reach for this as the hardware that joins the room rather than competing with it. The Dakota collection's companion knobs allow a mixed knob-and-pull program across doors and drawers in a single coordinated finish.
In most cases, yes. The mounting dimension here is 3-3/4 inch center-to-center, measured between the centers of the two screw holes. Measure your existing hole spacing to confirm before ordering, as some older pulls used a nominal size that did not match the actual drilling.
A mirror-polished chrome surface does show marks more readily than a brushed or matte finish. It wipes clean easily with a soft cloth, and the bright surface means light obscures light smudging in normal ambient conditions.
7/8 inch (22 mm) from the face of the front to the back of the grip, which is a close-set profile that keeps the pull from projecting far beyond the door plane.
Yes. The Dakota series includes companion knobs in the same design language and finish, so doors can be fitted with knobs while drawers run this pull, all under one coordinated program.
Choose this pull when the project calls for a bright chrome bar at the spacing that fits the most cabinetry without a drill bit in hand.
Sold In: 1 Each