Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Top Knobs Dakota pull is a traditional bar pull for cabinet doors and drawer fronts, sized for the 4 inch (102 mm) center-to-center hole pattern.
The 4 inch center-to-center is a natural fit for mid-size drawer fronts and upper cabinet doors where a 3-3/4 inch pull feels just short and anything wider starts to crowd the front. It is also the standard replacement spacing drilled into many factory-built cabinets, which makes this pull a straightforward swap when updating hardware without re-drilling. Because the overall length is 4-15/16 inches, there is a narrow border of pull beyond each post, which keeps the bar from reading as a stub while staying within the proportions of a standard door or drawer face.
The pull is cast in zinc and finished in Brushed Satin Nickel. The brushed texture scatters light rather than reflecting it cleanly, so the surface stays even across different lighting conditions and does not broadcast fingerprints the way a polished finish does. Satin Nickel reads as a cool, neutral silver that works alongside stainless appliances, chrome faucets, and brushed light fixtures without competing with them. On painted cabinetry in whites and grays it holds a quiet contrast; on wood-toned cabinetry it introduces a metal note that grounds the design.
This is a practical choice for a traditional or transitional kitchen, bathroom vanity, or built-in where the design language is restrained and the hardware should reinforce it rather than lead it. The Dakota collection is designed around that discipline: companion pieces share the same bar profile and finish, so mixing pulls on drawers with knobs on doors stays coherent. It also suits renovation and remodel work where the existing hole pattern is 4 inches and the goal is a clean hardware refresh without any drilling.
Center-to-center is the distance between the two mounting holes, 4 inches (102 mm), and is the measurement that must match your existing drilling. Overall length is the full end-to-end size of the pull at 4-15/16 inches and is larger than the hole spacing.
The projection is 1-1/16 inch (27 mm), so the back of the grip sits just over an inch from the face of the front.
Yes. Bar pulls of this form work on both cabinet doors and drawer fronts. Many kitchens run pulls on drawers and knobs on doors from the same collection for a coordinated look.
The cool silver tone of Brushed Satin Nickel sits close to standard stainless appliance finishes in appearance, making it one of the more natural pairings in a kitchen setting. Exact finish-to-finish matches across brands are never guaranteed.
When the drilling is already at 4 inches and the design calls for a brushed silver finish, this Dakota pull drops into place without compromise.
Sold In: 1 Each