Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Top Knobs Charlotte pull is a traditional bar pull from the Dakota series, built for cabinet doors and drawer fronts drilled on 3 inch (76 mm) centers.
The 3 inch center-to-center spacing is one of the standard hole patterns found across decades of residential cabinet construction, which makes this pull a practical fit for replacement work and new installs alike. On upper cabinet doors, a pull of this scale keeps the hardware proportional to the door width without overpowering it. It also works on narrower drawer fronts where a longer pull would crowd the panel. If the existing holes are drilled on 3 inch centers, this Charlotte pull drops in without additional drilling.
The pull is cast in zinc and finished in Polished Chrome. Chrome at this polish level is highly reflective, running a bright line along the bar where light hits it. That quality makes it a natural pairing with chrome faucets, light fixtures, and appliance trim already present in most traditional kitchens. Unlike a brushed or satin finish, polished chrome shows marks readily and wipes clean just as readily. On a traditional door program, the shine of the pull ties back to other bright metals in the room rather than introducing a separate tone.
This is a direct fit for cabinet shops and contractors running traditional or transitional kitchen programs where chrome hardware is specified across the door and drawer fronts. It is equally useful for homeowners replacing worn hardware on an existing cabinet bank drilled to 3 inch centers, since no new holes are needed. Designers specifying from the Dakota collection can pair this pull with the matching knobs in the same series on door fronts while running the pull on drawers, keeping the hardware in one visual family throughout the room.
Measure from the center of one hole to the center of the other. If that distance is 3 inches (76 mm), this pull mounts without new drilling.
The pull measures 3-1/2 inches (89 mm) end to end. Center-to-center is 3 inches, which is the drilling dimension; overall length is slightly larger and is a size and clearance figure.
Yes. The Dakota series includes companion knobs and additional pull sizes in the same design language and Polished Chrome finish.
Polished chrome and brushed stainless are different finishes and will read differently side by side. Where the appliances are polished stainless, the match is closer. Where they are brushed, there will be a visible contrast.
When the holes are already drilled on 3 inch centers and the finish program calls for polished chrome, this Charlotte pull from the Dakota collection covers both requirements without compromise.
Sold In: 1 Each