Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Top Knobs Devon pull is a bar-profile cabinet pull for doors and drawer fronts, mounting on 5-1/16 inch (128 mm) centers and finished in Ash Gray.
The 5-1/16 inch (128 mm) center-to-center is one of the most widely used hole spacings in cabinetry, common on upper doors, mid-width base drawers, and bathroom vanity fronts. It is a natural upgrade spacing for kitchens and baths that were built to that pattern, since a pull on 128 mm centers replaces an existing pull without touching a drill. It also works well on new construction where the 128 mm spacing suits the drawer width and the designer does not want to step up to a longer pull. At 6-3/8 inches overall, the bar has enough length to register visually on the front without demanding attention.
Ash Gray sits in an interesting position in the hardware palette. It is not a bright silver, not a satin nickel, and not a matte black: it is a mid-tone gray with a slight warmth to it that softens the cool edge you get from polished or brushed nickel. On white or off-white cabinetry it reads as a quiet contrast. On gray or greige fronts it blends rather than pops, which suits a kitchen or bath where the hardware should be present but not the focal point. On darker fronts it functions like a lighter accent without the hard edge of chrome. The pull is cast in zinc with the Ash Gray finish applied over it, and the bar section is squared at 11/16 inch wide, keeping the profile flat and linear against whatever front it lands on.
This pull is a practical fit for transitional kitchens and bathrooms where the hardware program needs to bridge contemporary cabinetry and warmer finishes elsewhere in the room. Ash Gray does that work without committing to either camp. It also suits renovation projects where the existing hole pattern is already at 128 mm, making the swap straightforward. Designers specifying a full kitchen will find the Devon collection useful because the series extends to knobs, additional pull lengths, and coordinating hardware, all under the same design language and finish name, so doors and drawers can carry matched hardware without sourcing across multiple lines.
It is a mid-tone gray, warmer and more muted than a standard satin nickel but lighter than a matte black. On most fronts it reads as a soft gray rather than pulling strongly toward either end of the spectrum.
Measure between the centers of your two existing screw holes. If that measurement is 5-1/16 inches (128 mm), this pull mounts without additional drilling.
Yes. The Devon series includes companion knobs and pulls in Ash Gray, so you can run knobs on doors and pulls on drawers within the same design language.
The bar is squared in profile at 11/16 inch wide, so the face is flat rather than rounded. It sits close to the door and reads as a line rather than a cylinder.
Choose this pull when the 128 mm hole pattern is already in place and the hardware should carry a finish that works with both warm and cool surroundings without committing to either.
Sold In: 1 Each