Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Top Knobs Devon series bar pull mounts on 5-1/16 inch (128 mm) centers and suits cabinet doors and drawer fronts where the hardware needs to hold its own without dominating the front.
The 5-1/16 inch center-to-center is a well-established cabinet hardware interval, sized between the common 3-3/4 inch drawer pulls and the longer 6-5/16 inch pulls used on wider fronts. That puts it in the range most often specified for mid-width base drawers, pantry doors, and upper cabinet doors on taller frameless boxes. If you are replacing existing hardware drilled to 128 mm centers, this pull drops onto those holes without touching the door. On a new build, 128 mm is a spacing worth planning for because it gives the front enough visual weight without pulling attention away from the cabinetry itself.
The pull is cast in zinc and finished in Polished Chrome. Chrome at this level of polish is a reflective, cool-toned surface that picks up its surroundings, which is part of what makes it a practical choice in kitchens and baths already running stainless appliances, chrome fixtures, or polished nickel accents. The bar section is 11/16 inch wide, flat on the face, so the surface that catches light is a broad plane rather than a thin highlight. On a horizontal pull that reads across a door or drawer, the effect is a steady band of brightness rather than a flash.
This is a pull that shows up in transitional kitchens, primary baths, and spec builds where chrome finishes already run through the plumbing fixtures and the appliance handles. Designers reaching for the Devon collection often do so because the line covers multiple center-to-center sizes in the same design language, which makes it straightforward to run 3-3/4 inch pulls on small drawers and 5-1/16 inch pulls on larger ones without breaking the hardware program. Cabinet shops installing to a specified finish and spacing will find 128 mm a common request from designers who prefer a longer pull on drawer banks and door stacks.
Drill two holes 5-1/16 inches (128 mm) apart, measured center to center. The pull measures 6-3/8 inches overall, so the ends extend roughly 5/8 inch beyond each hole.
A polished surface shows marks more readily than a brushed or matte finish and wipes clean just as easily. Kitchens with frequent use may prefer a brushed alternative; the Devon series is available in other finishes for that reason.
Yes. The Devon collection includes companion knobs in the same design language and Polished Chrome finish, which is the standard way to run pulls on drawers and knobs on doors within one series.
The 5-1/16 inch spacing works well on wider vanity drawers and door fronts, and Polished Chrome coordinates naturally with chrome plumbing fixtures.
When 128 mm centers are already in the plan and the finish program runs chrome, this Devon series pull covers both without compromise.
Sold In: 1 Each