Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Top Knobs Devon pull is a bar pull sized for wide drawers, oversized door panels, and appliance-scale fronts, mounting on 12 inch (305 mm) centers in Polished Nickel.
A pull at 12 inch centers is a deliberate choice for the largest hardware in a cabinet run. It suits deep pot drawers, wide base cabinet doors, pantry fronts, and refrigerator panel surrounds where a shorter pull would look underscaled against the front's width. The 13-5/16 inch overall length gives the bar physical presence without overwhelming a front, and the 11/16 inch cross-section keeps the profile lean enough to sit comfortably in a modern or transitional kitchen. This is not everyday-drawer hardware — it is the anchor piece that the rest of the kitchen pull program scales down from.
The pull is cast in zinc and finished in Polished Nickel. Polished Nickel is a mirror-bright surface with a slightly warmer undertone than chrome, which gives it depth in changing light without the yellow cast of polished brass. Against white or painted cabinet fronts it reads as a clean highlight. On stained wood it picks up the warm tones in the grain rather than fighting them. The polished surface shows handling marks more readily than a brushed finish does, and wipes clean just as easily — a relevant trade-off in a high-traffic kitchen at this hardware scale.
Cabinet shops specifying a full kitchen often anchor the hardware program with a pull at this center-to-center for the wide base drawers and then carry smaller Devon pulls down through the rest of the run. Designers working on transitional kitchens reach for Polished Nickel when the plumbing fixtures and appliance trim are already in a bright silver tone and the hardware should read as one consistent metal across the room. Homeowners replacing a single wide drawer pull who need to match an existing 12 inch hole pattern will find the drilling lines up without modification. All three groups benefit from the Devon collection's breadth: matching knobs and companion pulls in smaller centers are available in the same series and finish.
The center-to-center — 12 inches — is the distance between the two mounting holes and is what determines whether the pull fits your existing drilling or your planned layout. The overall length — 13-5/16 inches — is the full end-to-end size of the bar, which determines how far the pull extends past the holes on each side.
They are similar in brightness but not the same. Polished Nickel carries a slightly warmer, softer undertone compared to chrome's cooler, sharper reflection. Whether they read as matching depends on the specific fixtures in the room; confirm against the actual fixture finish before specifying.
The 12 inch center-to-center is the scale commonly used on appliance-panel cabinetry. This is a Devon collection cabinet pull typed as a standard pull by the manufacturer; confirm with your appliance or panel manufacturer that the mounting pattern and panel thickness suit your specific installation.
Yes. The Devon collection from Top Knobs includes companion pulls in several shorter center-to-center lengths and matching knobs, all available in Polished Nickel.
When the front is large enough to need hardware that commands it, this Devon pull at 12 inch centers in Polished Nickel delivers the length and the finish to match.
Sold In: 1 Each