Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Top Knobs Devon pull is a transitional bar pull for cabinet doors and drawer fronts, finished in Sable and sized to mount on 5-1/16 inch (128 mm) centers.
The 5-1/16 inch (128 mm) center-to-center is the standard mid-size cabinet drilling pattern, sized between the 3-3/4 inch pull common on narrower drawers and the 6-5/16 inch spacing used on wider ones. It lands comfortably on a 15 to 24 inch drawer front, which covers most base cabinet drawers, standard door pulls, and the middle tiers of a tall pantry. If the cabinetry is already drilled to this spacing, this pull drops onto the existing holes without touching a drill. For new construction, it is a familiar target for any cabinet shop.
The pull is cast in zinc and finished in Sable, a dark tone that sits closer to a warm charcoal than a flat black. The muted sheen keeps the surface from reading as glossy under kitchen or bath lighting, so the hardware holds its depth without flaring. Against light-painted fronts Sable reads as a strong contrast element. Against wood-stained fronts it blends with darker grain tones while still reading as hardware. At 3/4 inch wide, the bar is substantial enough to feel solid in the hand without dominating the door.
This pull suits transitional kitchens, bathrooms, and built-ins where the hardware program calls for a dark finish that is neither flat black nor bronze. It is a natural fit for a cabinet shop specifying a full Devon collection run, since matching knobs and companion pieces in the same series and finish are available. It also works for a homeowner replacing an existing set drilled to 128 mm centers, where the goal is a clean swap with no new holes. The 6-3/4 inch overall length gives the front a finished, proportional look on mid-width cabinetry.
Center-to-center is 5-1/16 inches (128 mm), the distance between the two mounting holes. That is the drilling dimension. Overall length is 6-3/4 inches, the full end-to-end size of the pull. Match your existing holes to the center-to-center figure, not the overall length.
Sable is a deep dark tone with a muted rather than flat surface. It reads warmer than a true flat black and does not have the high gloss of a polished finish.
The Devon collection includes companion knobs and other hardware pieces in the same design language and finish, so you can coordinate pulls on drawers with knobs on doors within one series.
The projection is 1 inch (25 mm) from the door face to the back of the bar, which keeps the pull sitting lean and close to the front.
Choose this pull when the project calls for a transitional Sable bar pull at the 5-1/16 inch (128 mm) spacing, whether that means a clean replacement job or a full Devon collection spec.
Sold In: 1 Each