Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Top Knobs Devon pull is a bar pull for cabinet doors and drawer fronts, mounting on the 3-3/4 inch center-to-center spacing found in more cabinetry than any other single drill pattern.
The 3-3/4 inch center-to-center dimension is the workhorse spacing of cabinet hardware. It fits the factory-drilled hole pattern on a wide range of stock and semi-custom cabinetry, which means this pull goes in without picking up a drill on a replacement project. On a new install it is a practical default for base drawers, upper doors, and vanity fronts where the hardware should sit proportionally without overwhelming the front. The 4 inch overall length keeps the footprint compact, so the pull does not crowd the edge on a narrower door or a shallow drawer.
The pull is cast in zinc and finished in Ash Gray. The tone sits in the cool silver family without the brightness of polished chrome or the warmth of a nickel, which makes it a quieter choice against both light and mid-tone cabinetry. A flat matte or satin gray finish like this one is less likely to show the fine surface scratches that a polished finish telegraphs over time in a working kitchen or bath. The slim 1/2 inch bar section keeps the geometry tight so the finish reads as a clean line on the door rather than a broad surface.
This pull fits naturally in a transitional kitchen or bath where the hardware program is neutral and the cabinetry does the visual work. Ash Gray coordinates comfortably with painted white, gray, or greige fronts, and it steps back from natural wood without competing with the grain. Because the Devon series includes companion pieces in the same collection, it is straightforward to run these pulls on drawers and source matching knobs on doors from the same line. It is also a practical choice for a reface or a partial refresh where the existing holes are already drilled at 3-3/4 inches and the goal is a clean hardware swap with minimal disruption.
Yes, provided your holes are centered at exactly 3-3/4 inches (95 mm) apart. Measure between the centers of your current holes before ordering to confirm.
It is a applied finish over a zinc base. The result is a cool gray tone rather than a bare metallic surface, so it reads as a color rather than as a shiny metal.
The Devon collection includes companion pieces across the series. Check the Devon series for matching knobs and other hardware in the same finish.
The bar is 1/2 inch (12.5 mm) wide, which gives it a slim, linear profile on the door.
Choose this pull when the hole pattern is already set at 3-3/4 inches and the hardware should disappear into a neutral gray rather than draw attention to itself.
Sold In: 1 Each