Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Top Knobs Edwardian pull is a traditional bar pull for cabinet doors and drawer fronts, built around the 3-3/4 inch center-to-center spacing that appears on more existing cabinet banks than any other single hole pattern.
A kitchen or bath refit usually comes down to one early question: does the new hardware land on the existing holes, or does the buyer refinish the doors? At 3-3/4 inch centers, this pull covers a hole pattern that was drilled on a significant share of the cabinetry installed over the past several decades. That makes it a natural fit for homeowners replacing worn or dated hardware without touching the fronts, as well as for contractors working through a renovation where original drilling determines what goes back in. The 4-7/16 inch overall length is proportional to a standard drawer front without overwhelming it, which is the balance that makes a traditional bar pull disappear into the cabinetry rather than compete with it.
The pull is cast in zinc and finished in Polished Chrome. Chrome is a bright, mirror-like surface that reads as neutral in most kitchen and bath settings because it already matches the faucet, the appliance trim, and the light fixture hardware in a wide range of existing interiors. On the squared 5/8 inch bar of this pull, the polish runs as a continuous highlight along the flat face, giving the pull a clean presence without adding visual weight. It is the pull for a room where the metals are already chrome and the hardware should join them rather than introduce something new.
This pull suits traditional and transitional kitchens, bathrooms, and utility spaces where the design program calls for classic proportions and a silver-tone finish. Because it belongs to the Edwardian collection, it coordinates with companion knobs and pulls in the same series, which makes it straightforward to run pulls on drawer fronts and match knobs on doors without pulling from two different design languages. It is also a practical choice for anyone managing a multi-room project where a consistent chrome finish across all the cabinetry is the goal and matching the existing hole pattern avoids unnecessary door repairs.
Yes. The 3-3/4 inch spacing on this pull is the same standard as 96 mm. The two values refer to the same hole pattern and are used interchangeably across the industry.
The projection is 1-1/4 inches (32 mm), measured from the face of the front to the back of the grip.
A polished surface picks up marks more readily than a brushed or matte finish. It wipes clean just as easily, but high-traffic drawers may need more frequent wiping.
The Edwardian collection includes companion pieces in the same design language and finish, so you can source knobs and pulls from one series.
Choose this pull when the hole pattern is 3-3/4 inches, the existing fixtures are chrome, and the hardware should blend into a traditional or transitional interior rather than stand apart from it.
Sold In: 1 Each