Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Top Knobs Ellis pull is a transitional bar pull for cabinet doors and drawer fronts, mounting on 5-1/16 inch (128 mm) centers, one of the most widely drilled spacings in residential cabinetry.
The 128 mm center-to-center is the spacing most cabinetmakers reach for when they want something wider than the 96 mm standard but do not yet need the full visual step up to 160 mm. That makes this pull the natural fit for mid-width drawers, standard upper-cabinet doors, and vanity fronts where the hardware should read as proportional to the front rather than undersized or oversized. It is also the right answer when an existing bank of cabinets is already drilled to 5-1/16 inch centers and the project calls for a hardware swap without redrilling.
The pull is cast in zinc and finished in Brushed Satin Nickel. The brushed texture diffuses light across the surface rather than reflecting it as a hard line, which keeps the hardware present without competing with tile, countertop, or cabinet color for attention. Satin nickel is a reliable neutral in transitional and contemporary kitchens because it reads silver without the high-contrast flash of a polished chrome or the warmth of a gold tone, sitting comfortably alongside stainless appliances, light fixtures, and faucets that share the same finish family.
This pull works for a homeowner replacing hardware on an existing cabinet run drilled to 128 mm centers, a designer specifying a transitional kitchen where satin nickel is already the hardware metal, or a cabinet shop stocking a reliable mid-size bar pull that lands across a broad range of frameless and face-frame builds. Because it belongs to the Ellis collection, knobs and complementary pull sizes in the same series carry the same design language and finish, making it straightforward to run this pull on drawers and coordinate Ellis knobs on doors without mixing visual programs.
Center-to-center is the distance between the two mounting holes and is the number to match against existing holes or a drilling template. Overall length is the full end-to-end size of the pull, which at 6-7/16 inches is about 1-3/8 inches longer than the hole spacing.
Yes. The two-hole surface-mount installation works on face-frame and frameless cabinets alike. Screw length will depend on the thickness of the door or drawer front.
The silver tone of Brushed Satin Nickel is compatible with most stainless appliance finishes in the same color family, though finish names across different manufacturers are not guaranteed to be an exact visual match.
The Ellis collection includes companion knobs and pulls in the same series. Look for Ellis collection pieces in Brushed Satin Nickel to keep the design language consistent across doors and drawers.
For cabinetry already drilled to 5-1/16 inch centers, or any new build calling for a transitional bar pull in brushed satin nickel, this Ellis pull drops in at the standard spacing and holds its finish across the kitchen.
Sold In: 1 Each