Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Top Knobs Ellis pull is a transitional bar pull for cabinet doors and drawer fronts, mounting on 6-5/16 inch (160 mm) centers.
The 6-5/16 inch center-to-center is a step up from the common 5-1/16 inch (128 mm) spacing, and that difference is intentional. At this hole pattern, the pull spans a wide base drawer, a deep pan drawer, or a full-height cabinet door with proportional weight. It reads as more than a detail without overwhelming the front it lands on. Shops and designers who spec a mix of drawer sizes typically reserve the 128 mm pulls for narrower runs and step up to 160 mm on anything wider, keeping the hardware weight in rough proportion to the front. This pull fits neatly into that approach.
The Ellis pull is cast in zinc and finished in Brushed Satin Nickel, a warm silver tone with a fine directional texture that takes the glare off the surface. Where a polished nickel reads bright and reflective, brushed satin stays consistent across changing light conditions in a kitchen or bath, which means it holds the same quiet presence whether the room is lit by daylight or under pendants in the evening. The 1 inch wide bar face gives the grip more visual mass than a slimmer round-section bar, while the brushed texture keeps that mass from looking heavy.
This pull is a practical choice for cabinet shops running transitional kitchen programs where the hardware needs to work beside both shaker and flat-front doors without committing hard to either style. The Ellis series is wide enough in scope to support a complete hardware program, with knobs and additional pull sizes in the same collection and finish, so a shop or designer can outfit an entire job from one series. Homeowners replacing hardware on a wider drawer bank drilled to 160 mm centers will find this a direct fit without redrilling. Designers specifying a kitchen where the existing faucet and fixtures are already in a brushed nickel family can lean on this pull to continue that metal thread through the cabinet hardware without forcing a match that only works from across the room.
Yes. The 160 mm center-to-center is the standard metric expression of the 6-5/16 inch spacing, and the two refer to the same hole pattern.
The grip is 1 inch (25 mm) wide, giving it more face presence than a slimmer round-section bar pull.
Brushed Satin Nickel is Top Knobs' finish name for this pull, and it reads as a warm silver-tone brushed surface. Finish tones vary between manufacturers, so it is worth comparing the two pieces side by side before committing to a full order.
Yes. The 160 mm spacing suits both wide drawers and full-height door fronts, and the transitional profile works equally well on either.
The Ellis series includes companion knobs and additional pull sizes in the same finish, so doors and drawers can be outfitted from one collection.
Choose this pull when the drawer or door calls for a center-to-center spacing that matches the scale of the front, finished in a brushed silver that stays consistent from morning light to evening.
Sold In: 1 Each