Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Top Knobs Ellis pull is a transitional bar pull for cabinet doors and drawer fronts, mounting on 3-3/4 inch centers in a Polished Nickel finish.
The 3-3/4 inch center-to-center spacing is the standard hole pattern on a wide range of stock and semi-custom cabinetry. On a replacement job, that means this pull goes in where the old one came out, with no new holes to drill and no filler to hide. On a new build, 3-3/4 inches is the spacing a cabinet shop reaches for first on upper doors and mid-width drawer fronts, which is why it appears on more installed kitchens than any other single measurement. The 4-1/8 inch overall length keeps the pull proportional on those fronts without overhanging the edges.
The pull is cast in zinc and finished in Polished Nickel. A polished surface on nickel reads as a bright, warm silver with more depth than chrome, and it picks up and reflects the ambient light in a kitchen rather than absorbing it. That quality makes it a natural companion to brushed or satin fixtures when the goal is a layered metal story rather than a perfectly matched one, though it also coordinates cleanly with other Polished Nickel pieces within the Ellis collection. The 5/8 inch bar width keeps the grip proportional to the overall length, so the pull reads as a refined detail rather than a structural element on the door.
This pull suits transitional kitchens and bathrooms where the hardware program needs to work with both the warmth of traditional wood cabinetry and the clean geometry of a contemporary slab or shaker front. Polished Nickel sits comfortably in that range: it is dressier than a brushed finish but less formal than polished brass, which gives it unusual range across project types. It is a practical choice for a designer specifying a full kitchen where knobs go on the doors and pulls go on the drawers from the same Ellis series, and it is equally practical for a homeowner replacing worn hardware on a bank of existing drawers drilled to this spacing.
Yes. The 3-3/4 inch measurement and 96 mm are the same standard cabinet spacing. This pull is the right fit for existing holes drilled to either value.
Polished Nickel has a slightly warmer, creamier tone than chrome. Both are bright finishes, but nickel reads softer and pairs naturally with warmer wood tones and aged or antique metal accents.
The Ellis collection includes companion knobs and pulls designed to coordinate, so pairing knobs on doors with this pull on drawers is a supported approach within the series.
1-1/8 inch (28 mm) from the face of the door or drawer front to the back of the grip.
Choose this Ellis pull when the project calls for a transitional bar pull at 3-3/4 inch centers and the finish needs the warm brightness of Polished Nickel rather than the cooler tone of chrome or the lower sheen of a brushed metal.
Sold In: 1 Each