Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Top Knobs Ellis pull is a transitional bar pull designed for cabinet doors and drawer fronts that need hardware with visual presence, mounted on 8-13/16 inch (224 mm) centers.
At 224 mm, this is hardware for the wide fronts in a kitchen or bath: deep base drawers, double-door pantry cabinets, full-height refrigerator panels, and vanity drawer banks that run three or four drawers across. A pull at this center-to-center provides a grip that feels proportional to the front rather than undersized, which matters when a drawer is heavy or used constantly. It also handles well on tall wall-cabinet doors where a shorter pull would leave too much unmarked door face above or below it.
The pull is cast in zinc and finished in Brushed Satin Nickel. The brushed surface scatters light instead of reflecting it in a single point, which keeps the finish looking consistent under both task lighting and natural light. Satin Nickel is a reliable neutral in a kitchen with stainless appliances, cool-toned countertops, or white and gray cabinetry, because it reads as the same metal family without an exact match being required. The slim 5/8 inch bar section keeps the profile linear and clean against flat-front and shaker-style doors without adding visual bulk.
Cabinet shops specifying a complete transitional kitchen will reach for this pull when the program calls for one hardware size to handle both the tall uppers and the deep base drawers, and the design language sits between contemporary and traditional rather than committing to either. Designers running a satin nickel program across faucets, lighting, and appliances will find this pull coordinates with that scheme without demanding a precise finish match. Homeowners replacing hardware on a wide drawer bank drilled to 224 mm centers get a straightforward swap with no new holes required.
The center-to-center distance, 8-13/16 inches (224 mm), is the spacing between your two mounting holes. The overall length, 9-3/16 inches (233 mm), is the full end-to-end size of the pull. Drill to the center-to-center measurement, not the overall length.
Yes. The Ellis collection includes companion knobs and pulls in the same design language and Brushed Satin Nickel finish, so you can mix pull sizes across drawers and doors and run knobs on door fronts within the same series.
No. Brushed Satin Nickel has a soft, matte texture with no high shine. Polished nickel is mirror-bright. The two read very differently under kitchen lighting.
This pull is intended for interior cabinetry. It is not rated for outdoor or wet-area installation.
When the drawer or door is wide enough that a shorter pull would look lost, this Ellis pull delivers the span and the finish to hold its place in the design.
Sold In: 1 Each