Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Top Knobs Ellis series pull is a transitional bar pull for cabinet doors and drawer fronts, mounting on 5-1/16 inch (128 mm) centers.
The 5-1/16 inch (128 mm) center-to-center is the spacing that shows up most often on mid-width base drawers and upper cabinet doors in standard residential kitchens. At this spacing the pull lands visually centered on a 12 to 18 inch front without crowding the edges, and it hits the same drill pattern used across a wide range of cabinet lines. For a shop running a full kitchen renovation or a contractor replacing hardware on an existing job, that shared hole pattern means no rerouting and no patching: mount and move on.
The pull is cast in zinc and finished in Flat Black, which is a matte rather than a satin or polished surface. Where a satin finish carries a soft sheen and a polished one reflects the room, Flat Black absorbs light evenly across the bar. That makes it consistent from any angle and forgiving of kitchen conditions: the surface does not pick up highlights from under-cabinet lighting or window glare. Against white, gray, or natural wood fronts it reads as a clean graphic line. Against dark fronts it holds its presence without competing with the cabinetry for attention.
Designers specifying a transitional kitchen reach for this pull when the room needs hardware that carries a contemporary edge without committing fully to a modern vocabulary. The squared bar and matte finish work equally well on a shaker door, a flat-panel slab, or a routed five-piece front. Cabinet shops ordering for a spec project appreciate that 128 mm is a drill pattern shared across most frameless and face-frame programs, which reduces layout complexity across a mixed order. Homeowners replacing existing hardware find it straightforward: if the current pulls are on 5-1/16 inch centers, this one fits without a template.
Measure from the center of one mounting hole to the center of the other. If that distance is 5-1/16 inches, this pull is a direct fit. The overall length of 7 inches is longer than the hole spacing, so the ends of the pull will overhang the holes on each side.
Flat Black and Matte Black are both low-sheen finishes, but they are separate catalog finishes from separate manufacturers. Do not assume one matches the other across brands or across product lines.
Yes. A bar pull of this profile works on drawer fronts and cabinet doors. The most common arrangement is pulls on drawers and matching knobs from the Ellis collection on doors, but the pull itself is not limited to one application.
The Ellis series from Top Knobs includes companion pieces in the same design language and Flat Black finish, so knobs and pulls in the collection coordinate with each other.
Choose this pull when 5-1/16 inch centers, a squared matte black bar, and a transitional profile need to work together across every door and drawer in the room.
Sold In: 1 Each