Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Top Knobs Ellis pull is a transitional bar pull for cabinet doors and drawer fronts, mounting on 6-5/16 inch (160 mm) centers in an Ash Gray finish.
The 6-5/16 inch center-to-center measurement sits at the step-up point in most hardware programs: wider than a standard base-drawer pull, not yet in appliance-pull territory. It is the natural fit for a 24-inch-wide drawer bank, a pot-and-pan drawer, a tall pantry door, or a sink base where the front is wide enough that a shorter pull looks under-scaled. Designers frequently run this spacing on all upper doors in a kitchen when the lower drawers carry the same series in a shorter length, because the matching finish and profile tie the two sizes together visually even though the centers differ.
The pull is cast in zinc and finished in Ash Gray. The finish sits in the Silver Tone color family but reads cooler and softer than a polished or brushed nickel would. On painted cabinetry it plays differently depending on the ground color: against true white it adds a warm gray accent, against a greige or putty front it nearly disappears into the palette, and against charcoal or navy it provides a tonal separation rather than a high-contrast edge. The slim 3/8 inch bar width keeps the hardware from reading as heavy even at this longer span, so the pull stays in proportion on a shaker or flat-panel door without dominating it.
This pull is a practical choice for cabinet shops and designers specifying a transitional kitchen or bath where the hardware program needs to carry across multiple front widths from a single series. Because it belongs to the Ellis collection, companion pieces in the same series cover shorter center-to-center spacings and matching knobs, which makes it possible to run one finish and one design language across every door and drawer in the room. It also works well in a renovation where the existing hole pattern is already drilled to 160 mm and the goal is a finish update rather than a redrilling job.
Ash Gray is a distinct finish name in the Top Knobs Ellis line. It reads cooler and more muted than a brushed nickel, with a flat gray character rather than the warm silver sheen of most brushed nickel finishes. The two are not the same and should not be assumed to match.
Sizing hardware to roughly a third of the front's width is a common design practice, which would put a 30-inch front in the range of a 9 to 10 inch pull. The 6-5/16 inch spacing is well suited to fronts in the 18 to 24 inch range. That said, proportion is a preference rather than a rule, and the final call belongs to the specifier.
Yes. The Ellis collection includes matching knobs and pulls in the same finish and design language, which is how most installations mix knobs on doors and pulls on drawers from a single series.
The overall length is 6-3/4 inches (171 mm), measured end to end. The center-to-center spacing is 6-5/16 inches (160 mm), which is the dimension that matches your existing holes or sets your drill pattern. The two numbers are always different on a bar pull.
When the goal is a transitional kitchen where every front, from the narrowest drawer to the widest pantry door, carries the same hardware language, the Ellis pull in Ash Gray at 160 mm centers is the size that covers the wide fronts without stepping out of the series.
Sold In: 1 Each