Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Top Knobs Ellis pull is a transitional bar pull for cabinet doors and drawer fronts, mounting on 3-3/4 inch centers in a Polished Nickel finish.
The 3-3/4 inch center-to-center measurement is the most widely drilled hole pattern in residential cabinetry. That matters most on a replacement or refresh project, where the goal is to drop new hardware onto holes that already exist rather than redrill every front in the kitchen. A pull at this spacing installs without a template on any cabinet already drilled to that standard. For a new build, it is also the spacing that gives a mid-size drawer a balanced look without the hardware dominating the front.
The pull is cast in zinc and finished in Polished Nickel. Polished Nickel is a bright, warm-silver finish, noticeably richer in tone than polished chrome and with a slightly warmer cast that reads well next to stainless appliances, brushed fixtures, or painted cabinetry in off-white and cream tones. On a flat bar the polish runs continuously along the face, so the pull catches light along its full length rather than at one point. The zinc substrate gives the bar its consistent cross-section and holds the finish evenly across the squared edges.
This pull suits transitional kitchens and baths where the hardware program calls for a clean, linear bar in a warm silver tone. It works equally well on upper doors and base drawers, and the 3-3/4 inch spacing makes it a practical choice for anyone updating existing hardware without drilling. Because it is part of the Ellis collection, companion knobs in the same series and finish are available for doors, which is the straightforward way to run a mixed hardware program without sourcing across brands or guessing at finishes.
Polished Nickel has a warmer, slightly yellow-toned silver compared to the cooler, bluer tone of polished chrome. The two are close in sheen level but distinct in color temperature, so they are not typically mixed on the same project.
If your existing pulls are drilled at 3-3/4 inch centers, yes. Measure between the centers of your current holes to confirm before ordering.
The Ellis series includes knobs, pulls at other center-to-center spacings, and backplates in matching finishes, so you can build a consistent hardware program from one collection.
The grip is a squared 5/8 inch bar, so the face is flat rather than curved. It sits tight against the door front and keeps a geometric, linear silhouette.
Choose this pull when the project calls for a bright Polished Nickel bar at the spacing that already fits most cabinet doors and drawers.
Sold In: 1 Each