Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Top Knobs Ellis pull is a transitional bar pull for cabinet drawers and doors, mounting on 7-9/16 inch (192 mm) centers in a Polished Nickel finish.
At 7-9/16 inches center-to-center, this pull is sized for the wider pieces in a cabinet run: deep base drawers, wide pantry doors, or the drawer stack on a furniture-style island. On a front of this scale, a shorter pull can look underweighted, while a pull drilled to 192 mm centers sits in proportion with the width of the door or drawer it lives on. If you are replacing existing hardware, this spacing drops onto a 7-9/16 inch hole pattern without any new drilling.
The pull is cast in zinc and finished in Polished Nickel. Polished Nickel is a bright, reflective surface with slightly warmer undertones than chrome, which makes it a natural fit alongside brushed nickel faucets or stainless appliances without being identical to either. On a slim 3/8 inch bar the polish catches and runs light along the full length of the grip, so the hardware reads as a clean horizontal line across the front. Zinc construction delivers the density and dimensional consistency that a well-finished pull requires at this scale.
The Ellis series is built around a transitional design language, which means it sits comfortably in kitchens and baths that blend traditional and contemporary elements. A polished nickel finish at this center-to-center spacing suits a shaker-door kitchen with warm wood tones, a painted vanity in a primary bath, or a built-in with furniture-style proportions. Designers who are running a mixed hardware program often pair this pull on wide drawers and pantry doors with a shorter Ellis pull or an Ellis knob on the upper doors, keeping the series consistent across the full run.
Polished Nickel has a similar brightness to chrome but carries slightly warmer, softer undertones. It is not the same finish as chrome, and the two are close enough to coordinate but different enough to notice side by side.
This spacing is well matched to deep base drawers, wide cabinet doors, and drawer stacks where a shorter pull would look underscaled. Sizing hardware to roughly a third of the front width is a common design guideline, though it is a preference rather than a fixed rule.
Yes. The Ellis series from Top Knobs includes companion pulls in other center-to-center sizes and matching knobs, so you can run a consistent hardware program across doors and drawers.
The 3/8 inch bar is a refined, narrow section. With 1-3/16 inch of projection behind it, there is adequate clearance for a natural grip on everyday use.
Choose this pull when the hardware needs to hold proportion on a wide drawer or a tall door, in a bright nickel finish that works across transitional and contemporary kitchens alike.
Sold In: 1 Each