Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Top Knobs Ellis pull is a transitional bar pull for cabinet doors and drawer fronts, finished in Polished Nickel and built to the 3-3/4 inch center-to-center spacing that fits the most common hole pattern in residential cabinetry.
The 3-3/4 inch center-to-center spacing is the standard that most cabinet manufacturers drill to on base drawers, upper door pairs, and vanity fronts. That means this pull drops onto an enormous range of existing hardware without a new drill pattern. For a kitchen remodel where the boxes stay and only the hardware changes, the 3-3/4 inch spacing is typically the first measurement a buyer confirms, and this pull delivers it in a finish and profile that suits transitional and contemporary interiors equally well. The 5-3/16 inch overall length keeps the pull proportional on fronts from about 12 inches wide up through a standard 18-inch drawer.
The pull is cast in zinc and finished in Polished Nickel. Polished Nickel is a bright, mirror-smooth surface in the silver-tone family, warmer than Polished Chrome and more reflective than a brushed or satin nickel. On a squared bar the polish runs continuously along the flat face, so the pull registers as a clean highlight against painted or wood-grain fronts. Zinc is the standard substrate for decorative cabinet hardware at this grade, and the Ellis series applies the finish evenly across the wider bar profile, which has more surface area to manage than a narrow bar or a round pull.
This pull is a natural choice for a transitional kitchen or bath where the hardware should coordinate with polished nickel faucets, light fixtures, or appliance trim without competing with them. At 3-3/4 inch centers it is the right fit for a standard upper cabinet door or a smaller base drawer, and the squared 1 inch bar keeps it from reading as too narrow on those fronts. Designers mixing hardware across a kitchen often pair this pull on drawers with an Ellis knob on doors, and because both pieces share the collection name and the same Polished Nickel finish, the visual match is direct rather than approximate.
Measure between the centers of your two existing holes. If that distance is 3-3/4 inches, this pull mounts without drilling. The overall length of 5-3/16 inches is the end-to-end size of the pull itself, which is always larger than the hole spacing.
They are both bright silver-tone finishes, but they are not the same. Polished Nickel carries a slightly warmer undertone than Polished Chrome. They can read similarly on cabinetry but will not be an exact match side by side.
Yes. The Ellis collection includes companion knobs in Polished Nickel that share the same design language, making it straightforward to run pulls on drawers and knobs on doors within the same series.
Flat and squared, at 1 inch wide. The face sits flush to the door rather than curving away from it.
For a hardware swap or a new build running 3-3/4 inch centers, the Ellis pull in Polished Nickel covers the most common hole pattern in a finish that coordinates across a full transitional hardware program.
Sold In: 1 Each