Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Top Knobs Ellis pull is a transitional bar pull for cabinet doors and drawer fronts, mounting on the 3-3/4 inch center-to-center spacing that appears on more existing cabinets than any other single drilling pattern.
The 3-3/4 inch center-to-center spacing is the dominant standard in residential cabinetry, which means this pull is the size a buyer reaches for when replacing hardware without drilling new holes. On a mid-width drawer it sits centered and proportionate. On an upper door it lands comfortably in the stile without crowding the edge. Because the hole pattern is already there on most stock and semi-custom cabinets, the swap is straightforward: pull the old hardware, confirm the spacing, and mount this one in its place.
The pull is cast in zinc and finished in Flat Black, a non-reflective black that reads as a flat plane rather than a surface. Unlike a polished or satin black, a flat finish absorbs light rather than returning it, which keeps the hardware from drawing attention to itself while still holding strong contrast against light cabinetry. Against a white or natural wood shaker front the pull registers as a clean graphic element. On a dark front it recedes and lets the cabinetry carry the room. The 1 inch wide squared bar profile reinforces that flatness: there is no curve to catch the light along the top.
This pull suits transitional and contemporary kitchens, bathrooms, and built-ins where the hardware program is black and the cabinetry is flat-fronted or frame-and-panel. It is a practical choice for a kitchen refresh where the existing drilling pattern is 3-3/4 inches and the goal is to update the finish without touching the doors. Because it belongs to the Ellis collection, companion knobs in the same series and finish are available for doors when the design calls for knobs on doors and pulls on drawers. Designers specifying across a full kitchen can run the Ellis line throughout and keep the hardware language consistent from base to upper.
If your existing holes are drilled on 3-3/4 inch centers, yes. Measure between the centers of your current mounting holes to confirm before ordering.
Flat Black is this manufacturer's finish name and describes a non-reflective, fully flat surface. Different brands may use similar names for finishes that look slightly different, so coordinate within the Ellis collection rather than across brands.
The bar is squared, 1 inch wide, so the face sits flat and does not introduce a curve against a straight door front.
The Ellis collection includes companion knobs in the same series and Flat Black finish, which is the standard way to carry one hardware language across doors and drawers.
When the existing drilling is 3-3/4 inches and the finish direction is flat black, this Ellis pull removes the guesswork from a hardware update and delivers a result that holds its look across transitional and contemporary spaces alike.
Sold In: 1 Each