Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Top Knobs Fulcrum pull is a contemporary cabinet pull for doors and drawer fronts, mounting on 3 inch (76 mm) centers in a Brushed Nickel finish.
The 3 inch (76 mm) hole pattern is the standard spacing on a wide share of production cabinet runs, which makes this pull a practical choice for replacing existing hardware without picking up a drill. It is also the spacing that suits narrower drawer fronts, door stiles, and upper cabinet doors where a longer pull would overhang the front or crowd the edge. At 4-11/16 inches overall, the Fulcrum sits proportionally on these fronts without looking undersized or stretched. For a kitchen running a mix of narrow and wide drawers, the 3 inch spacing is often the workhorse hole pattern that appears on the most doors in the room.
The pull is cast in zinc and finished in Brushed Nickel, a mid-sheen silver-toned finish that diffuses light rather than reflecting it as a sharp highlight. That surface behavior is useful in kitchens and baths where there is already a lot going on with fixtures, appliances, and tile. The brushed texture also softens the edges of the slim bar profile, keeping the overall look quiet and consistent under different lighting conditions. Brushed Nickel coordinates naturally with stainless steel appliances and chrome plumbing, which is one reason it remains a standard finish choice across contemporary and transitional hardware programs.
This pull suits cabinet shops and contractors running contemporary or transitional kitchens and baths where the hardware should recede rather than stand out. The slim bar profile and brushed finish make it a natural fit for flat-front and shaker cabinetry where the hardware line should stay tight to the door geometry. Homeowners replacing builder-grade hardware will find that 3 inch centers match the most common pre-drilled pattern in production cabinetry, reducing the likelihood of re-drilling. Designers specifying a full kitchen can lean on the Fulcrum collection for matching knobs on doors and pulls on drawers without introducing a visual gap between the two forms.
Yes. The 3 inch and 76 mm values refer to the same center-to-center spacing. Some manufacturers label the same pattern 76 mm and others label it 3 inch; they are interchangeable on standard tooling.
Measure from the center of one mounting hole to the center of the other. If that distance is 3 inches, this pull drops in without re-drilling.
Brushed Nickel is a silver-toned finish that coordinates well with stainless steel in most kitchens, though finish tones vary by manufacturer and a side-by-side comparison is the reliable way to confirm a match before committing to a full run.
Yes. The Fulcrum collection includes companion knobs in the same design language and Brushed Nickel finish for doors where a knob is preferred over a pull.
For cabinet fronts drilled on 3 inch centers, this Fulcrum pull delivers a slim contemporary bar in Brushed Nickel that fits the hole pattern already there and coordinates across the full Fulcrum collection.
Sold In: 1 Each