Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Top Knobs Dickinson pull is a traditional bar pull for cabinet doors and drawer fronts, sized for the 5-1/16 inch (128 mm) center-to-center spacing common on mid-width cabinetry.
The 128 mm center-to-center spacing lands in a productive middle range: wide enough to give a substantial grip on a base drawer or a full-height door, compact enough to clear the stile on a face-frame cabinet without crowding the edge. It is a natural fit on 15-inch to 24-inch drawer fronts and on door overlays where a narrower pull would look undersized. If existing hardware in the kitchen already runs on 128 mm holes, this pull drops straight onto that pattern without any new drilling.
The pull is cast in zinc and finished in Brushed Nickel. The brushed surface draws fine parallel lines across the metal and takes the glare off what would otherwise be a bright silver, so it reads as a cooler, quieter tone than polished nickel or polished chrome. In a kitchen with stainless appliances or a brushed nickel faucet, the finish coordinates without demanding attention. Against white or gray painted fronts it contributes contrast; against a warm wood stain it holds its own as a clean, neutral accent.
This pull works well in traditional and transitional kitchens, bathroom vanities, and built-in cabinetry where the hardware program leans toward a silver tone and the door style carries some detail. Designers specifying a full kitchen run will find Dickinson collection companions for the doors and smaller drawers, keeping the design language consistent across the whole installation. Contractors replacing hardware on an existing cabinet bank drilled to 128 mm centers will find the spacing straightforward to match.
5-1/16 inches is 128 mm, the standard metric spacing for this pull length. Both figures refer to the same hole pattern.
5-13/16 inches (148 mm) end to end, which is about 3/4 inch longer than the center-to-center distance on each side.
The bar is 1-1/4 inches wide with a flat face, so it sits squarely against the door front rather than presenting a curved profile.
The Dickinson series includes companion knobs in the same design language and finish, which is the standard way to run pulls on drawers and knobs on doors within one collection.
A brushed surface is more forgiving than a polished one because the texture breaks up the reflection, so marks are less visible at a glance, though they still wipe away easily with a damp cloth.
When the door and drawer count is high and the hole pattern is already at 128 mm, this pull gives a traditional kitchen a clean silver-tone line from one end of the run to the other without complicating the install.
Sold In: 1 Each