Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Top Knobs Edge Pulls tab pull mounts on 8-13/16 inch (224 mm) centers, a spacing scaled for wide drawer banks, full-height pantry doors, and tall cabinet fronts where a shorter pull would look out of proportion.
The 8-13/16 inch center-to-center dimension puts this pull in the range designers typically reach for on wide base drawers, full-overlay pantry doors, and appliance-adjacent tall cabinets. At that span, a shorter pull can look like it is floating in the middle of a large front, while a pull drilled to match the front's scale reads as intentional. This pull also works on furniture-scale cabinetry, island drawer stacks, and built-ins where the fronts are wide enough to carry hardware with a visible horizontal run. The tab form keeps the silhouette flat rather than projecting forward, which suits slab and minimalist shaker fronts where the hardware should add a line without adding bulk.
Aluminum is the base material here, which makes this pull lighter than a zinc equivalent of the same size without changing the finished appearance. On a 9-5/8 inch overall length that difference is perceptible when you are handling a full box. The Brushed Nickel finish is applied over that aluminum base: the brushed texture runs a fine directional grain across the surface that softens reflections rather than concentrating them. In kitchen and bath settings this finish integrates cleanly with stainless appliances, chrome fixtures, and nickel faucets without needing to be an exact match to any of them, because the brushed texture reads as a family of finish rather than a single point of color.
Cabinet shops laying out a contemporary kitchen with oversized drawer fronts will find this spacing useful for base cabinet drawers running 24 inches or wider, where a shorter pull leaves too much visual dead space to the left and right. Designers specifying a full kitchen program in the Edge Pulls collection can run this size on wide drawers and pair it with the shorter center-to-center variants on narrower doors, keeping a consistent profile and finish across the whole run. Homeowners replacing hardware on an existing bank drilled to 224 mm centers can use this as a direct swap without new drilling.
Center-to-center is 8-13/16 inches (224 mm), which is the distance between the two mounting holes and the number you match to existing holes or mark on a new front. Overall length is 9-5/8 inches (244 mm), the full end-to-end size of the pull. Drilling to the overall length would put the screws in the wrong position.
The brushed texture diffuses light and obscures surface marks better than a polished finish does. It is one of the lower-maintenance options in a silver-tone finish family.
Yes. Aluminum is lighter per unit volume than zinc, so a pull of this length in aluminum will be noticeably lighter to the hand than the same profile cast in zinc.
The Edge Pulls collection includes multiple center-to-center sizes in the same profile and finish. Running this size on wide drawers alongside shorter sizes on narrower doors or drawer fronts is a common approach for a consistent hardware program across a kitchen.
When the cabinetry is large, the hardware needs to match it. This pull's 8-13/16 inch spacing gives wide fronts the horizontal reach they need without changing the clean, low-profile tab form of the Edge Pulls series.
Sold In: 1 Each