Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Top Knobs Dot pull is a contemporary bar pull for cabinet doors and drawer fronts, mounting on the industry-standard 5-1/16 inch (128 mm) center-to-center spacing that appears on a wide range of factory-drilled cabinetry.
The 5-1/16 inch center-to-center is a practical centerpiece of the cabinet hardware world. It is one of the most widely drilled spacings in production cabinetry, which means this pull drops onto existing holes on a large share of kitchen, bath, and built-in installations without any additional drilling. For a remodel or a hardware refresh on factory-built cabinets, confirming that spacing is often all the homework required. At 5-7/16 inches end to end, the pull spans a width that suits a mid-size drawer or an upper cabinet door without overwhelming the front or reading as undersized.
The pull is cast in zinc and finished in Brushed Nickel. The brushed surface treatment creates a fine-grain texture that softens the finish into a warm silver tone rather than a hard mirror. In a kitchen or bath running other brushed or satin metal fixtures, this finish integrates rather than competes. Because the sheen is consistent across the grip and the posts, the pull reads as one piece against the front rather than as a bright spot at each fastening point. The slender 7/16 inch width keeps the geometry restrained, which suits the contemporary design language the Dot series is built around.
This pull suits any project where the existing hole spacing is 128 mm and the finish program is brushed or satin nickel. Cabinet shops and contractors fitting out production kitchens will recognize the spacing immediately. Homeowners replacing builder-grade hardware on cabinets from a box-store install or a tract build will find it a common match. Designers specifying a cohesive kitchen where pulls and knobs need to share a series can draw on the full Dot collection in the same finish to cover every door and drawer in the room without mixing design languages.
Measure between the centers of your two existing mounting holes. If that distance is 5-1/16 inches (128 mm), this pull mounts without drilling.
Yes. The Brushed Nickel finish covers the entire pull, including the posts, so there is no contrast between the grip and the mounting bases.
The Dot collection by Top Knobs includes companion pieces in the same series and finish, making it straightforward to mix knobs on doors and pulls on drawers across a single room.
A brushed finish hides marks better than a polished surface. The fine-grain texture diffuses light so smudges are much less visible than on a mirror-polished finish.
Choose this pull when the hole pattern is already there and the finish program calls for a soft, integrated silver tone that works with the room rather than drawing attention to the hardware.
Sold In: 1 Each