Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Top Knobs Dot pull is a contemporary cabinet pull for doors and drawer fronts, mounting on 5-1/16 inch (128 mm) centers in Polished Chrome.
128 mm is the spacing that shows up most often on factory-drilled cabinet fronts, which makes this pull the natural match when a kitchen is getting new hardware without new doors. The 5-1/16 inch center-to-center measurement drops onto that pattern without any additional drilling, and the 5-7/16 inch overall length provides just enough overhang to finish the grip cleanly on a mid-width drawer or upper door. For a shop building custom cabinetry and setting the drill pattern fresh, this spacing gives the buyer the widest selection of replacement hardware down the road.
The pull is cast in zinc and finished in Polished Chrome. Chrome at this level of polish runs as a continuous bright line across the face of the grip, picking up and reflecting ambient light rather than absorbing it. That behavior works in its favor in a kitchen that already carries chrome plumbing fixtures, appliance trim, or light hardware: the pull joins the existing metal program instead of introducing a contrasting tone. On dark cabinet fronts the reflective surface creates a clear visual boundary at each drawer; on light fronts it reads as a clean accent without visual weight.
This pull suits a contemporary kitchen, bath, or laundry room where the fixture and appliance finishes are already chrome or silver-toned and the cabinet hardware should coordinate rather than compete. It is a practical choice for a full kitchen replacement where uniformity across dozens of pulls matters as much as the individual piece, and a straightforward option for a retrofit where the existing hole pattern is already at 128 mm. The Dot collection includes companion pieces in the same series, so knobs on doors and pulls on drawers can be drawn from one consistent design language.
Yes. The 5-1/16 inch (128 mm) center-to-center value is the mounting dimension. Measure between the centers of your existing holes to confirm the match before ordering.
A polished surface is more likely to show prints and smudges than a brushed or matte finish, and it wipes clean just as readily. On kitchen hardware that gets daily use, a quick wipe is part of the routine.
The projection is 1-1/4 inches (32 mm) from the face of the door or drawer front to the back of the grip, which is comfortable for most hand sizes.
The Dot collection includes companion knobs and other pull sizes in the same design language. Look for Dot series pieces in Polished Chrome to keep the hardware consistent across doors and drawers.
Choose this pull when 128 mm centers are already in the doors and the hardware should carry a bright chrome line across mid-width fronts without introducing a second metal to the room.
Sold In: 1 Each