Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Top Knobs Browning pull is a traditional bar pull for cabinet doors and drawer fronts, mounting on the most common hole spacing in residential cabinetry.
The 3-3/4 inch (96 mm) center-to-center spacing is the single most prevalent hole pattern in residential cabinet manufacturing. That means this pull is often a no-drill replacement on existing cabinetry, which makes it a practical choice for a kitchen refresh, a bath update, or a furniture piece that already carries standard spacing. It also means a designer specifying it for new construction is working with a dimension that every cabinet shop and installer already knows. The 5 inch overall length gives the pull a small overhang past each hole, which is the usual proportion on a bar pull at this spacing.
The pull is cast in zinc and finished in Brushed Nickel, a cool silver-tone finish with a fine, linear texture that diffuses light rather than reflecting it. On a traditional kitchen or bathroom, brushed nickel reads as crisp without competing with stone, tile, or wood grain. The brushed texture also makes the surface more forgiving in daily use than a polished finish, since it does not spotlight every contact mark. Because the Browning series is a collection, the same Brushed Nickel finish and design language carry through companion pieces, so mixing knobs on doors with pulls on drawers stays consistent within one series.
This pull is a natural choice for a traditional or transitional kitchen where the hardware needs to coordinate with brushed nickel faucets, light fixtures, or appliance trim already in the room. At 3-3/4 inch centers it serves a wide range of drawer widths and door stiles without needing to reposition holes. Cabinet shops specifying hardware for a full kitchen run will find it an efficient choice at this spacing, and homeowners replacing a single handle on an existing bank of cabinetry drilled to 96 mm can install it without any drilling at all.
Yes. 3-3/4 inches converts to 95.25 mm, which the hardware industry rounds to 96 mm. The two values refer to the same standard hole spacing and this pull fits either.
If your current hardware is on 3-3/4 inch (96 mm) centers, this pull installs in the existing holes with no additional drilling needed.
The Browning series from Top Knobs includes companion pulls in other center-to-center sizes and matching knobs, all available in the same Brushed Nickel finish.
Bar pulls at this scale work on both. The 5 inch overall length and 3-3/4 inch spacing are proportioned for mid-width drawers and work equally well on upper cabinet doors.
At the industry's most common hole spacing and in a finish that coordinates with the broadest range of kitchen and bath fixtures, this Browning pull removes the guesswork from a hardware swap or a new spec.
Sold In: 1 Each