Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Top Knobs Alaire pull is a contemporary bar pull for cabinet doors and drawer fronts, built around the 5-1/16 inch (128 mm) center-to-center spacing that fits the most common mid-size hole pattern in residential cabinetry.
The 5-1/16 inch center-to-center dimension is one of the two or three hole patterns that show up most often in kitchen and bath cabinetry. On a standard base drawer or an upper door, this spacing gives the pull enough span to feel proportionate without running past the stile. For shops building new work, it is the spacing most clients expect on a mid-size drawer front. For homeowners replacing existing hardware, it is the measurement to confirm before ordering: if the existing holes are at 128 mm on center, this pull drops in without a drill.
The pull is cast in zinc and finished in Matte Black. The matte surface absorbs light rather than reflecting it, so the pull holds a consistent tone across the face of the cabinetry regardless of the light source in the room. On white or light-gray fronts it reads as a deliberate graphic element. On charcoal or deep-stained fronts it recedes into the door and lets the cabinetry carry the visual weight. The narrow 1/2 inch bar section reinforces that effect: there is not much surface area to catch attention, which is the point.
This pull suits contemporary kitchens, baths, and built-ins where the design intention is clean lines and a matte palette. It works on slab-front and shaker cabinetry, where a thin bar reads as part of the door geometry rather than as hardware added on top of it. Cabinet shops specifying a full kitchen in matte black will find the Alaire series covers the range of center-to-center spacings needed across drawers and doors of different widths, so a single collection handles the whole job. Designers replacing dated hardware on an existing build can match the 128 mm spacing directly on most mid-size drawers and upper cabinet doors without any additional drilling.
5-1/16 inches converts to approximately 128 mm, and both values refer to the same standard spacing. Either measurement can be used to confirm a match with existing holes.
Overall length is the end-to-end size of the pull including the posts and any overhang. Center-to-center is the distance between the two mounting holes only, and that is the number to match to the existing or planned hole pattern.
Matte Black is a low-sheen finish that shows fingerprints less readily than a polished surface. In a kitchen setting it generally wipes clean without leaving visible smears.
The Alaire collection includes companion pieces, so coordinating knobs for doors and pulls for drawers are available in the same design language and finish.
When the spacing is right, the installation is straightforward. The Alaire pull at 128 mm centers is built for the hole pattern that shows up most often in mid-size cabinetry, finished in a matte black that suits a contemporary room without demanding attention.
Sold In: 1 Each