Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Top Knobs Buckle Up pull is a contemporary bar pull for cabinet doors and drawer fronts, built around a 5-1/16 inch (128 mm) center-to-center spacing that lands squarely between the narrower three-inch pulls on small drawers and the longer runs on wide fronts.
The 5-1/16 inch (128 mm) center-to-center measurement is a standard in contemporary cabinet programs, drilled as a default on mid-size drawers, upper cabinet doors, and vanity fronts. If the existing hardware in a kitchen runs on 128 mm centers, this pull drops onto those holes with no new drilling. That makes it a practical choice for a targeted refresh — swapping pulls on a bank of base drawers or replacing hardware throughout the uppers — without touching the face frames. For new construction or a full remodel, the 128 mm pattern is widely supported by cabinet manufacturers and gives a pull of this overall length the right visual proportion across a mid-width front.
The pull is cast in zinc and finished in Matte Black. A matte surface does not pick up the reflections that a polished finish would under undercabinet or pendant lighting, which keeps the hardware from competing with the cabinetry in a room that is already working with strong light. Against white or light painted fronts, matte black reads as a clean graphic line. Against dark or charcoal fronts, the pull settles into the surface and lets the cabinet profile do the work. The rectangular grip section — 11/16 inch across — reinforces the flat, linear character of the design without adding visual bulk at the post.
Cabinet shops building contemporary kitchens and baths with 128 mm pre-drilled programs will find this pull a direct fit. Designers specifying a full hardware package across base, wall, and drawer units can carry the Buckle Up series through the whole project and match pulls to knobs without mixing collections. Homeowners replacing worn or dated hardware on a kitchen that was already drilled to 128 mm centers can change the look without any cabinet work. This is a mid-scale pull, and it works best where the front is wide enough to carry the 8 inch overall length without the pull running edge to edge.
Measure from the center of one mounting hole to the center of the other. If that distance is 5-1/16 inches (128 mm), this pull is a direct replacement.
No. 128 mm converts to 5-1/16 inches, not 5 inches flat. A pull drilled on 5 inch centers will not line up with existing 128 mm holes.
A matte finish conceals oils and smudges better than a polished surface, which makes it a practical choice in high-use kitchens.
The Buckle Up collection includes companion pieces in the same design language and finish, so knobs on doors and pulls on drawers can come from one series.
Choose this pull when the cabinet program runs on 128 mm centers and the finish should hold contrast without adding glare.
Sold In: 1 Each