Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Top Knobs Wadsworth pull is a D-handle cabinet pull for drawer fronts and cabinet doors, mounting on the most common hole spacing in residential cabinetry.
The 3-3/4 inch center-to-center is the standard hole spacing on base drawers, upper door pairs, and vanity fronts across decades of residential cabinetry. A replacement job drilled to that spacing drops this pull in without touching a drill, which is the practical case for this size over a longer pull on narrower fronts. The D-handle profile suits a mid-width drawer or a standard upper door where the hardware should frame the front rather than span it. It also reads well on a vanity or a built-in, wherever the project calls for hardware that is finished-looking without being decorative.
The pull is cast in zinc and finished in Brushed Nickel. Brushed Nickel sits in the silver-tone family but reads warmer and quieter than Polished Chrome. The brushed texture diffuses light across the grip rather than reflecting it as a bright line, so the hardware recedes into a light cabinet face and holds its own against a dark one. It is a finish that coordinates readily with stainless appliances and brushed fixture trims without demanding an exact match, which makes it a practical choice on a spec build or a remodel where the surrounding metals were not all chosen at once.
This pull suits a homeowner replacing worn or mismatched hardware on a standard cabinet run, a designer specifying transitional hardware that works across multiple clients' finishes, and a cabinet shop looking for a versatile pull to stock across kitchen and bath projects. Because it belongs to the Wadsworth collection, companion knobs and pulls in the same series carry the same design language and finish, which makes it straightforward to mix knobs on doors and pulls on drawers without sourcing from multiple series.
Yes. The 3-3/4 inch center-to-center is the same as 96 mm. This pull seats directly on an existing 96 mm hole pattern with no additional drilling.
A D-handle has a curved or arched grip that returns to the door face at both ends, enclosing the hand. A bar pull carries a straight grip on two open posts. The D-handle gives a slightly more finished silhouette because there are no open ends.
1-3/8 inches (35 mm), measured from the door face to the back of the grip.
Brushed Nickel is a silver-tone finish that reads close to brushed stainless in most lighting conditions and coordinates well in mixed-metal kitchens. It is not an exact match for any specific appliance finish.
Choose this pull when the project needs hardware that fits the most common cabinet hole pattern and delivers a clean, transitional look in Brushed Nickel without requiring a full redesign around the hardware.
Sold In: 1 Each