Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Top Knobs Conga pull is a contemporary bar pull for cabinet doors and drawer fronts, mounting on 5-1/16 inch (128 mm) centers in a Warm Brass finish.
The 5-1/16 inch center-to-center is the spacing that bridges the gap between the standard 3-3/4 inch pulls on narrow drawers and the longer spans used on wide base drawers. It is common on mid-width base drawers, drawer stacks where the fronts run 15 to 18 inches wide, and upper cabinet doors where a pull of this length reads as proportionate without dominating the front. If the existing hardware on a bank of drawers was drilled to 128 mm centers, this pull drops directly onto those holes. At 7-3/8 inches overall, there is enough visual length to anchor a mid-size front while the slim 7/16 inch bar keeps the profile lean.
Warm Brass sits in a different register than polished brass or satin brass. The surface carries a softness that reads closer to an antique gold tone than to a bright metal, which means it works with natural wood cabinetry, painted fronts in warm whites and greens, and rooms that already run unlacquered or aged brass fixtures. Because it is a matte-adjacent rather than a mirrored finish, it holds its appearance under kitchen light without throwing glare along the bar. The pull is cast in zinc, the dominant base material across this segment, which gives the Warm Brass finish a consistent surface to sit on.
This is the right pull for a kitchen or bath renovation where the designer has committed to a warm gold tone and needs a 128 mm pull to match an existing drilling pattern or to work across mid-size fronts. It is a natural fit for transitional and contemporary kitchens running shaker or slab doors, and it pairs well with unlacquered brass faucets, light fixtures with warm metal accents, and cabinetry in natural wood, sage, or off-white. Cabinet shops and contractors specifying hardware for a full kitchen run can coordinate knobs and other pull sizes from the Conga collection in the same finish, so the hardware program stays consistent from the smallest door to the widest drawer.
The mounting holes are 5-1/16 inches (128 mm) apart, measured center to center. That is the figure to match if you are replacing existing hardware or laying out new holes.
The projection is 1-3/16 inches (30 mm), measured from the door face to the back of the grip bar.
Warm Brass is the finish name for this Top Knobs Conga SKU specifically. Finish names are not standardized across manufacturers, so this finish should be coordinated with other Conga series hardware rather than assumed to match another brand's brass.
The bar is 7/16 inch wide, with a slim profile. Refer to product images for the exact cross-section geometry.
Choose this pull when a 128 mm hole pattern and a warm brass tone are the two non-negotiables on the job, and the hardware should stay refined rather than decorative.
Sold In: 1 Each