Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
This Top Knobs Conga pull is a contemporary bar pull for cabinet doors and drawer fronts, mounting on 5-1/16 inch (128 mm) centers.
The 5-1/16 inch center-to-center measurement is one of the most widely used cabinet drilling patterns, found on base cabinets, drawer banks, and upper doors from most domestic cabinet programs. That makes this pull a common drop-in replacement when a kitchen is being updated rather than rebuilt. On a mid-width drawer, this spacing puts both mounting points well within the structural zone of the front, which matters for a pull that will be gripped and pulled several hundred times a year. The 7-3/8 inch overall length gives the hand room without overrunning narrower fronts.
The pull is cast in zinc and finished in Brushed Nickel, a matte-silver finish that holds a steady appearance across different lighting conditions. Where a polished nickel reads differently in morning light versus incandescent evening light, a brushed surface stays consistent. It also handles contact well: the brushed texture breaks up the surface enough that ordinary marks from daily use are not the first thing you see. Brushed Nickel sits in the Silver Tone color family and coordinates with stainless appliances, chrome plumbing fixtures, and other silver-family hardware in the same room, though cross-brand finish matching is not guaranteed.
This pull fits a contemporary kitchen, bath, or built-in where the cabinetry is flat-fronted or shaker-style and the hardware should stay understated. Designers specifying a full kitchen often run this spacing on base drawers and doors simultaneously, where the 128 mm center-to-center aligns with standard pre-drilled cabinet lines and simplifies the install. Renovation contractors appreciate it for the same reason: one hole pattern, no custom drilling, and a finish family that plays well with the fixtures already in the room. Because it is part of the Conga collection, companion pieces in the same series are available for mixing knobs on doors with pulls on drawers.
Measure the distance between the centers of your two existing screw holes. If that measurement is 5-1/16 inches (128 mm), this pull mounts without any new drilling.
The bar is 7/16 inch wide and linear in profile, so the grip face is narrow and straight rather than round.
Less than a polished surface does. The brushed texture scatters light rather than reflecting it evenly, which makes everyday contact marks much less visible.
The Conga series includes companion knobs and pulls, so coordinating door knobs with drawer pulls within the collection is a straightforward approach.
Choose this pull when the 5-1/16 inch hole pattern is already in place and the hardware needs to read as a quiet, consistent silver tone across a contemporary cabinet program.
Sold In: 1 Each