Order by 24/7 by web, contact our sales reps or call by phone.
What you need, when you need it, all in one place.
Most orders ship same day.
Advice and support from knowledgeable professionals.
The Top Knobs Conga pull is a contemporary bar pull for cabinet doors and drawer fronts, mounted on 5-1/16 inch (128 mm) centers.
The 5-1/16 inch center-to-center is the standard hole pattern for a wide swath of residential cabinet builds, particularly on base drawer banks and full-overlay door pairs where the hardware needs to read at scale. At that spacing, the 7-3/8 inch bar extends well beyond the mounting posts on each side, giving the pull a longer visual line than the holes it sits on. That proportion suits a 12 to 18 inch drawer front well, where a shorter pull would look understated relative to the panel behind it. It also works cleanly on upper doors and pantry fronts where the mounting holes were already drilled to this common spacing.
The pull is cast in zinc and finished in Matte Black. The low-sheen surface absorbs rather than reflects light, which keeps the hardware from competing with the cabinetry in kitchens or baths that rely on contrast as a design move. Against white or natural wood fronts the matte black bar holds its edge as a graphic line. Against dark fronts it recedes and lets the door or drawer take the attention. The 7/16 inch bar section is narrow enough to read as a trim detail rather than as a heavy handle, which is what gives this pull its contemporary character.
This is a practical choice for designers and cabinet shops specifying contemporary kitchens, baths, or built-ins where the hardware program is matte black and the hole pattern is already at 128 mm. It also suits homeowners replacing existing hardware on a drawer bank drilled to this spacing, since the mounting centers match without re-drilling. The Conga collection pairs this pull with knobs and companion pulls at other centers, making it straightforward to run a consistent look across doors and drawers from one series.
The pull measures 7-3/8 inches end to end but mounts on 5-1/16 inch (128 mm) centers. The extra length beyond the posts is what gives it its proportioned look on the door — the bar extends past the screws on each side rather than ending flush with them.
Yes. Other pieces in the Conga series carry the same Matte Black finish designation, so knobs and pulls from the same collection coordinate without mixing finishes.
The bar is a narrow rectangular section, 7/16 inch wide, so it presents a flat face rather than a rounded profile against the door front.
If the existing holes are drilled to 5-1/16 inch (128 mm) centers, this pull drops onto them. Measure between the centers of the existing holes before ordering to confirm.
At 128 mm centers and 7-3/8 inches overall, this pull covers the mid-scale fronts in a contemporary kitchen and coordinates with the rest of the Conga collection so the hardware reads as a single program from room to room.
Sold In: 1 Each